Page 2 - Customer Service; Australia Only; Monday to Friday 8am - 5pm AEST; Do not return to place of purchase.; Keep your purchase receipt, this will be required to; INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS
3 2 Safety Before attempting to operate this heater, the following basic safety precautions should be taken to reduce the risk of fire, electric shock and personal injury. It is important to read the instruction manual and to understand its’ applications, limitations and potential hazards associated...
Page 3 - SPECIFIC SAFETY INSTRUCTIONS; WARNINGS
3 2 SPECIFIC SAFETY INSTRUCTIONS WARNINGS Do not use the heater in areas where there is a risk of explosion or fire from flammable gases. Ensure that the heating area is kept clear of combustible materials. Do not use the heater in damp areas, without suitable ventilation. This heater is not designe...
Page 4 - MODEL; ASSEMBLY; HEATER HEAD; ELECTRICAL DATA
5 4 IMPORTANT This product is fitted with a sealed electrical connection plug that is compatible with the heater, the mains supply for Australia and meets the requirements of international standards. This heater must be connected to a supply voltage that is equal to that stated on the rating label. ...
Page 5 - GENERAL MOUNTING SUGGESTIONS; WALL/CEILING BRACKET ASSEMBLY; NOTE: To adjust bracket position, see bottom page 4; MOUNTING HEATER
5 4 GENERAL MOUNTING SUGGESTIONS If unsure please discuss with your local hardware store. • Ensure the fixing screws are at least suitable for 10Kg each.• If fitting to a stud wall or ceiling ensure all fixing screws are into timber. Plasterboard IS NOT suitable by itself. • If no timber stud/joists...
Page 6 - TO TILT HEAD; CEILING MOUNT WITH CHAIN
7 6 TO TILT HEAD Note: Always ensure that the heater is switched off, disconnected from the mains power supply and is cold to touch. If heater has been recently used, please leave the wall heater one (1) hour to cool before tilting head.1. Loosen the locking bolt and remove.2. Loosen the head tilt b...
Page 7 - HEATER POSITIONING
7 6 HEATER POSITIONING 1. Position heater at least 200mm from the eave lining or ceiling or wall at 90˚ to heater. 2. Position heater at least 1.8m above the floor.3. Never position in front, above or below a power point.4. If heater is facing another vertical surface, example – wall, the gap must b...
