Garmin PN 906-2001-00- Manuals

Page 2 - port; Press and hold the right straight arrow button to make a; starboard; Remember safe and prudent operation of the; How To Turn the Autopilot on:

Press and release Deckmount (on/off) button, usually found on stern of boat close to the out board. The deckmount light and standby LED on the hand held will both blink, the autopilot system is in a start-up mode and no operations are available for 30 seconds. When the STBY LED turns solid press the...

Page 3 - time using the feature operation changes.; How to adjust throttle:

When the button is pressed the LED next to 9 will come on, the system will drop out of autopilot and put you in a starboard remote turn. To return to autopilot press and release the right straight arrow button. When the button is pressed the LED next to 6 will come on, the system will drop out of au...

Page 4 - to change feature options.; How to Select Feature Operations; the Select Load Button, then press and

Press and hold to change feature options. Turn back light on or off LED’s Bright or Dim Step Turns to PortCircle Turns to PortRemote Turn to Port Step Turns to StarboardCircle Turns to StarboardRemote Turn to Starboard Man Over BoardIdle/ResumeZig-Zag patterns GPSReverse How to Select Feature Operat...

Page 5 - How to Setup Steering Patterns

The following will lead through the following features step by step, Reverse, MOB, Idle/Resume, Zig- Zags, Step Turns, Circles and Remote Steer. Reverse: The Autopilot will attempt to perform any of it’s steering functions when the boat is backing in reverse gear. To engage the system in reverse; 1)...

Page 6 - System SETUP and Codes; Push and release to access setup mode.; How to Make System Changes with Setup

System SETUP and Codes Push and release to access setup mode. Select code numbers 1, 2, or 3 Select code numbers 7, 8, or 9 Increase value of code settings Select code numbers 4, 5, or 6 Save setup change Decrease value of code settings How to Make System Changes with Setup (How to change the parame...

Page 7 - Table of Setup Codes

Setup Action Code # Range of Settings or Responses Factory Default Setting Tach on/off 34 2 Settings: on or off on Show motor RPM 36 Hold Down Select Load Button: 1000’s blink on up arrow 100’s blink on down arrow Standby Safety Monitor 349 2 settings on, off defaults to on every power up on Throttl...

Page 8 - Compass Calibration, Autopilot Tuning and Setup; Standby

Compass Calibration, Autopilot Tuning and Setup 1) Calibrate your Compass. Compass calibration is a very important step and must be done. (North needs to be set also for GPS functions.) Find some smooth water where you can drive in circles without running into anything. • With the Pilot in Standby m...

Page 9 - Compass Calibration; Example of button sequence below; tiller or main engine) and start your first 360 degree circle.

Compass Calibration Example of button sequence below; Autopilot in Standby 3) Press and hold the button, now press and release the Deckmount (on/off) button quickly, the Up Arrow LED will now come on now release button 2) Now press button the 4 LED will now be on. Now press button the 7 LED will now...