Fujitsu ASTG07CMCB - Manuals

Page 2 - Indoor unit accessories; WARNING

En-2 OPERATING MANUAL WARNING • Do not install the unit in area ¿ lled with mineral oil such as a factory or area containing a large amount of splashed oil or steam such as a kitchen. • Do not start or stop the operation of this product by inserting or pulling out the power plug, or by turning on or...

Page 3 - AIR CONDITIONER Wall Mounted Type; Indoor Unit Overview and Operations

En-3 AIR CONDITIONER Wall Mounted Type OPERATING MANUAL 1 Intake grille Before starting operation, make sure that the intake grille has been shut completely. Incomplete closing may have an effect on the proper function or performance of the product. 2 MANUAL AUTO button Use when the remote controlle...

Page 4 - Remote Controller Overview and Operations; You can quickly start operation with the following 3 steps:

En-4 OPERATING MANUAL CAUTION • To prevent malfunction or damage of the remote controller: - Place remote controller at where will not be exposed to direct sunlight or excessive heat. - Remove batteries if the product is not going to be used for an extended period. - Exhausted batteries must be remo...

Page 5 - Remote Controller Overview and Operations (continued); RESET

En-5 AIR CONDITIONER Wall Mounted Type OPERATING MANUAL Remote Controller Overview and Operations (continued) 7 Signal transmitter Aim at the signal receiver of the indoor unit properly.• Signal transmit indicator on the remote controller display shows that the signal from the remote controller is b...

Page 6 - OPERATING MANUAL; Remote controller custom code setting; Timer Operation; ON timer or OFF timer

En-6 OPERATING MANUAL Note for timer settings: Any interruption of the power supply, such as a blackout or cutting off of a circuit breaker, makes the set internal clock incorrect.In such a case, the TIMER indicator on the indoor unit blinks, and you need to readjust the setting. Remote controller...

Page 8 - About the HUMAN SENSOR; Demand Response and Indoor Unit Operation; About the ENERGY SAVING Operation

En-8 OPERATING MANUAL 90° 7 m 7 m 50° 50° Ɣ Application range is follows. Vertical angle 90° (Side view) Horizontal angle 100° (Top view) ENERGY SAVING function may not work when the room temperature is very different from the temperature de ¿ ned in temperature setting, such as when immediately aft...

Page 9 - General Informations on Operation; Auto-restart function; Temperature and Humidity Range

En-9 AIR CONDITIONER Wall Mounted Type OPERATING MANUAL General Informations on Operation Auto-restart function In event of power interruption such as a blackout, the air conditioner stops once. But it restarts automatically and performs previous operation when the power supply is resumed. If any po...

Page 10 - Care and Cleaning

En-10 OPERATING MANUAL Care and Cleaning CAUTION • Before cleaning the indoor unit, be sure to turn it off and all the power supply has been disconnected. • Before starting operation, make sure that the intake grille has been shut completely. Incomplete closing of the intake grille might have an eff...

Page 11 - Replacing the air cleaning; After extended non-use of the unit

En-11 AIR CONDITIONER Wall Mounted Type OPERATING MANUAL Care and Cleaning Replacing the air cleaning ¿ lter 1 Remove the air ¿ lter. (Refer to step 1 in “Replacing the air ¿ lter”.) 2 Release 2 latches a of the ¿ lter holder, and turn over the holder in direction of arrow b . Remove the soiled air ...

Page 12 - Troubleshooting

En-12 OPERATING MANUAL WARNING In following events, immediately stop operation of the air conditioner, and disconnect all the power supply by turning off the electrical breaker or disconnecting the power plug. Then consult your dealer or authorized service personnel.As long as the unit is connected ...