Frigidaire FFRE4120SW - Manuals

5 INSTALLATION REQUIREMENTS WARNING EXPLOSION HAZARD Uncoated copper tubing will corrode when subjected to natural gas, causing gas leaks. Use ONLY black iron, stainless steel, or plastic-coated brass piping for gas supply. Gas supply requirements Correct Correct Incorrect Incorrect 1 Installation M...

6 INSTALLATION REQUIREMENTS Exhaust DirectionDirectional exhausting can be accomplished by installing a quick-turn 90° dryer vent elbow directly to exhaust outlet of dryer. Dryer vent elbows are available through your local parts distributor or hardware store. See also Clearance Requirements on the ...

8 INSTALLATION REQUIREMENTS Clearance requirements IMPORTANT DO NOT INSTALL YOUR DRYER: 1 In an area exposed to dripping water or outside weather conditions. 2 In an area where it will come in contact with curtains, drapes, or anything that will obstruct the fl ow of combustion and ventilation air. ...

9 INSTALLATION REQUIREMENTS 14.9” (37.8 cm) to center of rear vent 12.1” (30.8 cm) centerline height for rear vent 27” (68.6 cm) 30.8” (78.2 cm) to front of closed door 48.6” (123.5 cm) to clear open door fl oor line 2.6” (6.5 cm) 5.1” (12.8 cm) 3.7” (9.5 cm) 44.2” (112 cm) 38.5” (97.5 cm) gas suppl...

11 INSTALLATION INSTRUCTIONS Electrical connection (non-Canada) - 3 wire cord 3-wire receptacle (NEMA type 10-30R) Neutral Neutral (center wire) (center wire) 30 AMP 30 AMP NEMA 10-30 NEMA 10-30 DO NOT remove internal ground in a 3-wire system!! Neutral terminal Terminal cover 1 Turn off power suppl...

13 INSTALLATION INSTRUCTIONS Gas connection All connections must be wrench-tightened Flare Union Flare Union GAS FLOW Manual Shutoff Valve Closed Open Flexible Connector Inlet Pipe on Back of Dryer e l p p i N Shutoff Valve - Open position to dr yer from gas supply 1 Remove the shipping cap from gas...

14 INSTALLATION INSTRUCTIONS General installation 1 Connect the exhaust duct to the outside exhaust system. Use of a 4” (102 mm) clamp (item A) is recommended to connect the dryer to the exhaust vent system. Use metal foil tape to seal all other joints. 2 Use a carpenter’s level to level your dryer ...

15 REVERSING DOOR 1 Open the door and begin removing the four screws that attach the hinge to the front panel door opening. Start by only removing one screw per hinge. Then only loosen the two remaining screws while fi rmly holding the door to prevent damage to hinge, front panel or door. After the ...

17 ACCESSORIES LP CONVERSION KIT P/N HA004 Gas dryers intended for use in a location supplied with LP must use a conversion kit prior to installation. UNIVERSAL APPLIANCE WRENCH P/N 137019200 A UNIVERSAL APPLIANCE WRENCH is available to aid in dryer/washer/pedestal feet adjustment. TOUCH UP PAINT PE...