Friedrich MW30C3G - Manuals

En-6 To Select Mode Operation 1 Press the START/STOP button (Fig.6 P ). The indoor unit’s OPERATION Indicator Lamp (red) (Fig. 3 5 ) will light. The air conditioner will start operating. 2 Press the MASTER CONTROL button (Fig.6 J ) to select the desired mode. Each time the button is pressed, the mod...

En-7 To Stop Operation Press the START/STOP button (Fig. 6 P ). The OPERATION Indicator Lamp (red) (Fig. 3 5 ) will go out. About AUTO CHANGEOVER Operation AUTO: ● When AUTO CHANGEOVER operation fi rst selected, the fan will operate at very low speed for about one minute, during which time the unit ...

En-8 TIMER OPERATION Before using the timer function, be sure that the Remote Controller is set to the correct current time ( ☞ P. 5). To Use the ON timer or OFF timer 1 Press the START/STOP button (Fig. 6 P ) (if the unit is already operating, proceed to step 2). The indoor unit’s OPERATION Indicat...

En-9 SLEEP TIMER OPERATION Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operate is stopped. To Use the SLEEP Timer While the air conditioner is operating or stopped, press the SLEEP button (Fig. 6 I ). The indoor unit’s OPERATION Indicator Lam...

En-10 ADJUSTING THE DIRECTION OF AIR CIRCULATION ● Adjust the up, down, left, and right AIR directions with the AIR DIRECTION buttons on the Remote Controller. ● Use the AIR DIRECTION buttons after the Indoor Unit has started operating and the air fl ow-direction louvers have stopped mov- ing. DANGE...

En-11 To select SWING Operation Press the SWING button (Fig. 6 S ). The SWING Display (Fig. 7 a ) will light. Each time the SWING button is pressed, the swing operation will change in the following order. To stop SWING Operation Press the SWING button and select STOP. Air fl ow direction will return...

En-12 Cleaning the Intake Grille 1. Remove the Intake Grille. 1 Place your fi ngers at both lower ends of the grille panel, and lift forward; if the grille seems to catch partway through its movement, continue lifting upward to remove. 2 Pull past the intermediate catch and open the Intake Grille wi...

En-13 TROUBLESHOOTING WARNING! In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the electrical breaker or disconnect the power supply plug, and consult authorized service personnel.Merely turning off the unit’s power switch will not completely disconnect the ...

En-14 TROUBLESHOOTING OPERATING TIPS Symptom Problem See Page CHECK ONCE MORE Doesn’t operate at all: ● Is the Power Supply Plug disconnected its outlet? ● Has there been a power failure? ● Has a fuse blown out, or a circuit breaker been tripped? — ● Is the timer operating? 8 - 9 P o o r C o o l i n...

En-15 OPERATING TIPS Temperature and Humidity Range Cooling Mode Dry Mode Outdoor temperature About 14 to 115 °F About 14 to 115 °F Indoor temperature About 64 to 90 °F About 64 to 90 °F ● If the air conditioner is used under higher temperature conditioner than those listed, the built-in protection ...

Friedrich Air Conditioning Co. 4200 N. Pan Am San Antonio, Texas 78218 USA Tel. (210) 357-4400 Fax (210) 357-4490 Visit us at www. friedrich. com 9315345394_OM.indb 19 9315345394_OM.indb 19 9/30/2010 2:44:34 PM 9/30/2010 2:44:34 PM