Page 2 - Assembled Parts; CAUTION; This product contains small parts in an unassembled state.; Shown Actual Size
1 Assembled Parts Upper Ramp Large Tree Canopy Teeter-totter Handle Gate Platform Peek-a-boo Door Flag Base Canopy Swing Hut Roof Wall Tree Lower Ramp Part not shown: Label Sheet CAUTION This product contains small parts in an unassembled state. Adult assembly is required. Base #6 x 5 8 " (1,6 c...
Page 3 - Assembly; Screw
2 • Turn the assembly over. • Fit the post on the teeter-totter into the hole in the wall assembly. Hint: You may need to turn the teeter-totter to fit it in place. • Push to “ snap ” in place. • Fit the tree onto the wall. • Lay the assembly face down on a fl at surface and insert a screw into the w...
Page 4 - snap; snap
3 • Turn the assembly upright. • Fit the tabs on to the bottom of the wall assembly into the slots in the base. Hint: If the tabs on the wall assembly do not seem to fit, turn it around and try again! • Push near each tab to “ snap ” in place. 3 Assembly • At an angle, fi t the peg on one side of the...
Page 5 - Back View
4 Assembly • First fi t the tab on the platform into the slot in the backside of the wall A . Then, fi t the upper ramp into the slot in the front of the wall B . • Push to “ snap ” the platform and upper ramp into the wall. 6 Upper Ramp Platform Back View Back View A B • From the back of the wall ass...
Page 8 - Decoration; Flag
7 • Before applying the labels, wipe the surface with a clean, dry cloth to remove any dust or oils.• Place the labels exactly as shown in the illustration and avoid repositioning the labels.• After applying a label, rub it fi rmly with a clean dry cloth, starting at the center, to remove any air bub...
Page 9 - alkaline; Battery Installation
8 • Locate the battery compartment door on the bottom of the toy. • Loosen the screw in the battery compartment door and remove it. • Insert three, new “AA” (LR6) alkaline batteries. Hint: We recommend using alkaline batteries for longer battery life. • Replace the battery compartment door and tight...
Page 10 - Battery Safety Information
9 ICES-003 NMB-003 • This Class B digital apparatus complies with Canadian ICES-003. • Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired o...
Page 12 - CONSUMER ASSISTANCE
FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipm...