Fisher-Price L1154 - Manuals

Parts Piezas All Shown Actual Size Se muestra a tamaño real 5 Lock Nut – 2 Tuerca ciega – 2 #6 x 1 1 / 4 " (3.18 cm) Screw – 2 Tornillo #6 x 1 1 / 4 " (3,18 cm) – 2 1.5” (3.8 cm) Pin Screw – 2 Tornillo de clavija de 1,5” (3,8 cm) – 2 Note: Tighten or loosen all screws with a Phillips screwdr...

Assembly Montaje 6 2 • Pull the other leg back until it “snaps” into place in the housing. • Repeat this procedure to “snap” the leg in the other housing into place. • Jalar la otra pata para atrás hasta que se ajuste en su lugar en el compartimento. • Repetir este procedimiento para ajustar la pata...

Assembly Montaje 7 4 • Check to be sure you have assembled the leg assemblies to the bases correctly. Please refer to the illustrations above.• If the leg assemblies are assembled incorrectly to the bases, simply pull the legs from the bases. Please re-read and repeat assembly step 3. • Set the fram...

Assembly Montaje 8 6 Seat Bottom Asiento Round EndSeat Tube Tubo de asiento de extremo redondo Armrest Holes Orificios del reposabrazos • Position the seat bottom so that the back faces you and the armrest holes are facing up. • Locate the round end seat tube. Hint: Look at opening in the straight e...

Assembly Montaje 11 • Fit the ends of the seat back wire into the outside holes in the seat tubes. • Introducir los extremos del tubo del respaldo en los orificios exteriores de los tubos del asiento. 12 • Attach a lock nut, rounded side facing out, onto one end of a seat back wire. • Tighten the lo...

Assembly Montaje 12 Seat Tubes Tubos del asiento •Insert the ends of the seat tubes into the holes in the hubs. • Push the seat tubes in until you hear a “snap” (for each). • Push down on the seat to be sure the seat is secured in both frame hubs. • Introducir los extremos de los tubos del asiento e...

Assembly Montaje 14 • From behind the seat, fit the pad elastic loops to the tabs on the seat back. • Desde el dorso del asiento, ajustar las ondas elásticas de la parte de arriba de la almohadilla en las lengüetasdel respaldo. Elastic Loops Onda elásticas Tabs Lengüetas 18 • Fit the crotch belt thr...

Assembly Montaje 15 Toy Bar Hubs Conexiones de la barra de juguetes • Fit the toybar hubs to the seat tubes. Hint: The toybar hubs are designed to fit to the seat tubes one way. If the toybar hubs do not fit correctly,turn the toybar around and try again. • Insert a #8 x 7 / 8 " (2,2 cm) screw t...

Hint: We recommend using alkaline batteries for longer battery life. Nota: Se recomienda usar pilas alcalinas para una mayor duración. 1.5V x 4 “D” (LR20) • Protect the environment by not disposing of this product with household waste (2002/96/EC).Check your local authority for recycling adviceand f...

To prevent serious injury or death from falls and being strangled in the restraint system: • Always use restraint system. Never rely on the tray to restrain child. • Never use with an active child who may be able to climb out of the product. • Never leave child unattended. Para evitar lesiones grave...

18 Setup and Use Preparación y uso Securing Your Child • Place your child in the seat. Position the crotch belt between your child’s legs. • Fasten the waist belts to the crotch belt. Make sure you hear a “click” on both sides. • Check to be sure the restraint system is securely attached by pulling ...

19 Setup and Use Preparación y uso Swinging • Make sure your child is properly secured in the seat.• Slide the swing power switch on to any of six speed settings. The power indicator lights. • Be sure to slide the switch to the off position when the swing is not in use. Hint: As with most battery-po...

UPRIGHT VERTICAL 20 Setup and Use Preparación y uso Adjusting the SeatAdjust the seat angle to any of three positions: Upright, Semi-Recline or Recline. To adjust theseat angle: • Lift or lower the seat wire into the grooves on the seat back. Adjusting the SeatAjustar el ángulo del asiento en una de...

21 Setup and Use Preparación y uso Parent Activated • Slide the mode switch to Parent Activated. • Mom can activate up to 10 minutes of music along with lights and action. Hint: Baby can enjoy lights, music and motion with or without swinging! Baby Activated • Slide the mode switch to Baby Activated...

22 Care and Storage Mantenimiento y Almacenamiento To remove the pad: • Remove the four pad elastic loops from the seat back and bottom tabs. • Remove the top of the pad from the seat. Para retirar la almohadilla: • Quitar las cuatro ondas elásticas de la almohadilla de las lengüetas del asiento y r...

23 Care and Storage Mantenimiento y Almacenamiento PRESS BUTTONPRESIONAR BOTONES • Press the button on each housing and push the rear legs toward the front legs. Stand the frame against a wallfor storage. • Presionar el botón de cada compartimento y empujar las patas traseras hacia las patas delante...