Page 3 - alkaline; CAUTION; This product contains small parts
3 IMPORTANT INFORMATION IMPORTANT INFORMATION • Please keep this Owner’s Manual for future reference, as it contains important information. • Adult assembly is required. You may need the assistance of another adult to complete assembly. • Do not use Shot Block ™ Basketball in a room with direct sunl...
Page 4 - Part not shown: Label Sheet
4 PARTS PARTS 2 3 1 4 1 Backboard 2 Chute 3 U Tube 4 Door Clip 5 2 Pivot Tubes (Left and Right) 5 Part not shown: Label Sheet
Page 5 - Tubes
5 6 8 7 Tip: All fasteners shown actual size. Note: Tighten and loosen all bolts and screws with a Phillips screwdriver. Do not over-tighten the fasteners. We’ve included extra fasteners for your convenience! M5 x 23 mm Bolt – 8 #8 x 1" Screw – 4 M5 Lock Nut – 8 9 6 2 Tubes (Left and Right) 7 2 ...
Page 6 - Remove the battery compartment door.; • Replace the battery compartment door and tighten the screws.; Battery; BATTERY SAFETY INFORMATION; under adult supervision.; SHOWN ACTUAL SIZE
6 BATTERY INSTALLATION BATTERY INSTALLATION • Loosen the screws in the battery compartment door on the back of the backboard. Remove the battery compartment door. • Insert four "C" (LR14) alkaline batteries. • Replace the battery compartment door and tighten the screws. Tip: When sounds, lig...
Page 7 - • Before applying the labels, wipe all
7 DECORATION DECORATION • Before applying the labels, wipe all surfaces with a clean, dry cloth to remove any dust or oils. • Apply the labels as indicated in the illustrations. 4 5 1 2 3 7 8 9 10 6 6 11 12 13 ™ ™ 19 14 15 16 17 18
Page 9 - ASSEMBLY
9 STEP 1 • Place the backboard face down on a flat surface. • Fit the ends of the U tube into the grooves in the bottom of the backboard. U Tube Backboard Grooves ASSEMBLY ASSEMBLY
Page 13 - Loops
13 STEP 5 • Next, position the hinge tubes so that the rounded side is up. • Match the hinge tube with the white dot to the pivot tube withthe white dot. • Next, slide the hinge tubes into the next two loops on the chute,as shown. Loops Hinge Tubes (Rounded Side Up) White Dot White Dot
Page 14 - Hinge Tube; White Dot
14 STEP 6 • Fit the end of each hinge tube into the end of each pivot tube. Hint: If the hinge tubes do not fit in the pivot tubes, reverse the hinge tubes. Make sure the white dot on the hinge tube matches the white dot on the pivot tube. Hinge Tube Pivot Tube ASSEMBLY ASSEMBLY White Dot White Dot
Page 15 - rounded side out; , to the hex hole in the opposite side of each; Pivot
15 STEP 7 • Insert an M5 x 23 mm bolt through the outside of each pivot tube. • Fit an M5 lock nut, rounded side out , to the hex hole in the opposite side of each pivot tube. • While holding the lock nut in place, tighten the bolt in each pivot tube. Pivot Tubes Rounded Side
Page 17 - rounded side up; , to the hex hole in the opposite side of each tube.; Rounded
17 STEP 9 • Insert an M5 x 23 mm bolt through the underside of each tube. • Fit an M5 lock nut, rounded side up , to the hex hole in the opposite side of each tube. • While holding the lock nut in place, tighten the bolt. Rounded Side
Page 20 - • Wrap the straps on the chute around the handle and fasten.; Straps
20 STEP 12 • Wrap the straps on the chute around the handle and fasten. Straps ASSEMBLY ASSEMBLY
Page 24 - the chute clips to the handle.; Assembly is now complete.
24 STEP 16 • "Snap" the chute clips to the handle. • Lower the net. Assembly is now complete. Chute Clips Handle ASSEMBLY ASSEMBLY
Page 26 - BEGINNER
26 FREEPLAY FREEPLAY • First, slide the power switch to ON . • Next, slide the level switch to Beginner. • Press the Freeplay button. • Shoot the basketball into the basket. • Look at the scoreboard to see how many baskets you've made! • First, slide the power switch to ON . • Next, slide the level ...
Page 27 - ONE ON ONE
27 SIZZLING SHOT CLOC K ™ SIZZLING SHOT CLOCK ™ • First, slide the power switch to ON . • Next, slide the level switch to Beginner. • Press the Sizzling Shot Clock ™ button. • Look at the scoreboard. You have 24 seconds to make 4 baskets. • Shoot the basketball into the basket. Each basket scores 2 ...
Page 28 - • Grasp the joints on the chute and lift.; Joint; FOLDING THE CHUTE
28 STEP 1 • Grasp the joints on the chute and lift. Joint Joint FOLDING THE CHUTE FOLDING THE CHUTE
Page 30 - • Lift the upper rim and snap; Rim
30 30 STORAGE STORAGE STEP 1 • Lift the upper rim and snap into place. • Push the lower ring into upper rim. Rim Rim Lower Ring
Page 31 - Chute
31 STEP 2 • Grasp the joints on the chute and lift. Chute Joint Joint
Page 32 - • Grasp the joints on the
32 STORAGE STORAGE Joint Joint STEP 3 • Grasp the joints on the chute and lift. • Tuck the chute inward. Retainer Joint Joint Retainer
Page 33 - • Fold the net brackets inward.; Net Bracket
33 STEP 4 • Fold the net brackets inward. Net Bracket Net Bracket
Page 34 - SYMPTOM
34 TROUBLESHOOTING GUIDE TROUBLESHOOTING GUIDE SYMPTOM SOLUTION • The scoring mechanism is sensitive to lighting conditions. Do not use the Shot Block TM Basketball in areas of direct sunlight. Do not use outdoors or in front of a window. • Shot Block™ Basketball goes into "sleep mode" after...
Page 35 - CARE; Wipe clean to remove soap residue.
35 CONSUMER INFORMATION CONSUMER INFORMATION QUESTIONS? Visit us on-line at www.service.mattel.com . Or, call Fisher-Price ® Consumer Relations, toll-free at 1-800-432-5437 , 8 AM- 6 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470. Write t...