Page 2 - on an elevated surface.; WARNING; Warning and Caution; This package contains small parts; CAUTION; Consumer Information
2 To prevent serious injury or deathfrom falls and being strangled inthe restraint system: - Always use the restraint system.- Not recommended for children who can sit up by themselves(6 months approximately, until9 kg, 20 lbs). • Never leave child unattended.• It is dangerous to use this product on...
Page 3 - Parts
3 Parts 3 Link Toys Seat Back Tube Pad Front Tube Lower Swing Arm Assembly (with Restraint System) Frame 2 Frame Tubes Shown Actual Size #6 x 1.9 cm Screws - 4 NOTE: Tighten and loosen all screws with a Phillips screwdriver.Do not over-tighten the screws.
Page 4 - Assembly
4 Assembly • Rotate the upper frame tube until it "snaps" into an upright position, as shown. IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharpedges. DO NOT use if any parts are missing or broken.Contact Mattel for replacement parts a...
Page 8 - Assembly is now complete.
10 8 Assembly • From behind the seat, insert the waist belts into the slots inthe pad. • Push to fasten the restraint system to the pad. Assembly is now complete. Slot Slot Waist Belts Fastener • Fit the top pocket on the pad over the seat back tube . • Lift the seat bottom tube and fit the lower po...
Page 9 - Battery Installation
9 Battery Installation 1.5V x 4 LR14 SHOWN ACTUAL SIZE Hint: We recommend using alkaline batteries for longer battery life. • Locate the battery compartment door on the frame. • Loosen the screws in the battery compartment door. • Remove the battery compartment door and the battery holder from the b...
Page 10 - Battery Safety Information
Battery Safety Information Batteries may leak fluids that can cause a chemical burninjury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of differenttypes: alkaline, standard (carbon-zinc) or rechargeable(nickel-cadmium). • Insert batteries as indicat...
Page 11 - Securing Your Child; Loosen
11 Set-Up & Use • Place your child in the seat. Position the crotch belt betweenyour child’s legs. • Fasten the waist belts to the crotch belt. Make sure you hear a “click” on both sides. • Check to be sure the restraint system is securely attached bypulling it away from your child. The restrain...
Page 12 - Starting the Swing
12 Set-Up & Use Power Dial Power Dial Starting the Swing • Turn the power dial to any of eight settings. • Give the seat a light push to start the swinging motion. Adjust the swing power dial to the desired swing motion setting. Hint: As with most battery-powered swings, a heavier child will red...
Page 13 - Baby Activated; Parent Activated
Baby Activated 13 Set-Up & Use Hint: Your baby can enjoy lights and music with or without swinging. Parent Activated • Slide the lights and music switch to: When baby pulls either toy on the arch, one tune plays along with twinkling lights. On this setting, six tunes (approximately 10 minutes) p...
Page 15 - Take Along
15 Take Along • Lift the seat back and seat bottom together. • Tip the swing backwards with the seat back down. • Press both tabs on the frame at the same time to release theframe base. 1 2 Lift Seat Bottom Lift Seat Back Seat Back Press Tabs
Page 16 - Care
Care • The frame, pad, liner and toys may be wiped clean using amild cleaning solution and a damp cloth. Do not immerse the frame. • This product has no consumer serviceable parts. Do nottake this product apart. IMPORTANT! Never use this product without the provided pad. Fisher-Price, Inc., a subsid...