Page 2 - Parts; to push up on hands or knees.; WARNING
Parts 2 Clamp Crib Adapter Base 3 Butterfly Spokes 3 Soft Toy Spokes 3 Soft Toys Arm Hub #6 x 5 / 8 " Screw - 1 Both Shown Actual Size #4 x 3 / 8 " Washer Head Screw - 3 Remote 2 • A crib mobile is intended for visual stimulation and is not to be grasped by a child.• When used on a dresser t...
Page 3 - Mobile Features
Light Dome – Projects butterflies and leaves onto baby’s ceiling. Start Button – Starts or restarts music and soothing lights. Light Select Button – Choose dome light, night light, both lights or no lights. Song Select Button – Press to choose from six different songs. Power/Volume Switch - Choose h...
Page 4 - Remote Features; Rear View
Remote Features 4 Button - Press to activate the mobile once the mobile has been turned ON. Press again to stop the mobile. LED Signal Indicator - Lights when the button is pressed to let you know the remote has transmitted a signal to the transmitter. Transmitter Window - Remote transmits a signal ...
Page 5 - alkaline; Battery Installation; Mobile Base
Mobile Base • Locate the battery compart- ment door on the back of themobile base. • Loosen the screws in the battery compartment door with a Phillipsscrewdriver. Remove the batterycompartment door. Hint: If the crib adaptor is attached to the base, loosen the screws in the cribadaptor and remove it...
Page 6 - Battery Safety Information; Shown Actual Size
Batteries may leak fluids that can cause a chemical burn injury or ruin yourtoy. To avoid battery leakage:• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartm...
Page 7 - “snap”; Assembly
• Locate the three butterfly spokes.• Insert and “snap” the tabs on the ends of the butterfly spokes into the slots in the hub, as shown. Assembly 7 Butterfly Spoke Tab Slot Hub • Locate the three soft toy spokes.• Place the end of the spoke with the larger hole onto the matching hole on the hub, as...
Page 9 - Crib Use
Crib Use 9 Battery Compartment Door Crib Adapter Tighten Screws • Position the base so that the battery compartment door is facing you.• Fit the crib adapter onto the base.• Tighten the three screws in the crib adapter using a Phillips screwdriver. Do not over-tighten.
Page 11 - Use; Mobile Dome
Use 11 IMPORTANT! • In the unlikely event that use of the remote interferes with normal use of other remote controlled equipment, such as televisions and stereos, or useof other electric or battery powered appliances interfere with operation ofthe mobile, do not use both appliances at the same time....
Page 14 - Locate the Knob; Pull Knob Out
14 • Locate the knob on the arm.• Grasp the knob and pull it out.• Rotate the arm to an angled position as shown.• Release the knob to lock the arm in position.• Place the mobile on a dresser top out of reach of baby. Locate the Knob Dresser-top Use Knob Knob Dresser-top Use Pull Knob Out
Page 15 - Soft Toys; The Mobile; Care
Soft Toys • To remove a soft toy, grasp its string and press the knot up through the opening in the spoke. • Slide the string through the slot in the spoke.• Place the soft toys in a pillowcase. Wash them on a gentle cycle in cold water. Tumble dry the toys on low heat. Do not use bleach. The Mobile...
Page 16 - Consumer Information
Consumer Information PRINTED IN CHINA C0108a-0920 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmful interferencein a residential instal...