Page 2 - WARNING; To avoid serious injury:; • Adult supervision is required.; Consumer Information
WARNING To avoid serious injury: • Adult supervision is required. • Never use near cars and other motor vehicles, near streets, steps, sloped driveways, hills, roadways, alleys, swimming pools or other bodies of water. • Always wear shoes or sneakers. • Never allow more than one (1) rider. Call Fish...
Page 4 - This product contains small parts; Bottom View; CAUTION
Assembly Assembly • Please save all packaging material until assembly is complete to ensure that no parts are discarded.• Wipe each part with a clean, dry, cloth before assembling this product. This product contains small parts in its unassembled state. Adult assembly is required. • Place one end of...
Page 5 - Gently pull the
Assembly Assembly 4 • Turn the frame on its side with the exposed end of the straight axle up. • Slide the other rear wheel (spoke side up) onto the end of the straight axle. • Place a cap nut on the end of the straight axle.• Cover the cap nut with the assembly tool.• Tap the assembly tool with a h...
Page 6 - Make sure the fork is; Assembly
• Turn the frame upright.• Insert the fork post up through the hole in the frame neck. Make sure the fork is positioned so that the fork covers facethe rear wheels. • Place the electronic handlebar over the fork post and push it down ontothe frame. Make sure the handlebar is positioned sothat the sc...
Page 9 - alkaline; Care; Battery Installation; SHOWN; Storage; Battery Safety Information
9 9 • Loosen both screws in the battery compartment door and remove it. • Insert three “AA” (LR6) alkaline batteries. • Replace the battery compartment door and tighten the screws. Hint: When sounds or lights slow/stop/dim, it’s time to replace the batteries. Care Care • Check plastic parts regularl...
Page 10 - Secure the Base; “snap” it into place
10 10 Rock Mode Rock Mode Secure the Base IMPORTANT! Be sure to adjust the seat in the most forward position for Rock mode. • Insert the base/handle pin through one wheel retainer, a hole in the front wheel and into the other wheel retainer. • Push the handle pin to “snap” it into place . Pull on th...
Page 11 - Make sure; Roll Mode; Press and hold the roll button; Convert to Roll Mode
• Insert the handle pin through oneside of thebase/handle,through the holesin the back of theframe and outthrough the holein the other sideof the base/han-dle. Make sure the handle pin“snaps” intoplace. • Pull on the handle pin to besure it is secure. 11 11 Roll Mode Roll Mode Base/Handle Handle Pin...
Page 12 - Press and hold the ride button; Convert to Ride Mode
12 12 • Rotate the base/handledown, underthe trike, tothe rock position. 12 12 Base/Handle Base/Handle Base/Handle Cover • Remove the screws fromthe base/han-dle covers. • Remove the base/handlecovers. • Remove the base/handle. • Rotate the footrest upand snap itinto therecess in theunderside ofthe ...