Fisher & Paykel P120LS - Manuals

cabinet construction IMPORTANT NOTIceFor a refrigerator to function to its optimum standard it requires a certain amount of air clearance around the cabinet. With integration the cabinet is essentially sealed up. As a result, the products energy, temperature and/or basic performance could be affecte...

Hinges Full overlay Half overlay Inserted door Butt hinge Door closed Door op en Door op en Door op en Door op en Door closed Door closed Must add 30mm (2") to dimension A&B Illustrated below are some of the types of hinging that can be used. 790, 680 & 635 ModelsIt is recommended that 1...

1 Prepare Refrigerator for Installationa) Check that the internal cupboard dimensions are correct (see page 3) Unpack refrigerator protecting the floor and/or paint work from damage. b) Check that refrigerator door is hinged on desired side. Refer to use & care booklet for instructions to change...

Tasman Models With Plastic Handles 1. There are 3 screws on the PC door and two on the FC door that hold on the Tasman handles. 2. Remove cap-covering screws and remove screws, as shown below3. Remove handle Curved Door Models 1. Remove door end cap to expose the door handle plate.2. Remove screw wh...

Tilt the product back and remove the levelling foot circular base insert from the front levelling feet, a small flat blade screw driver can be used. Lift the product into the cabinet Diagram 5 Lift the front edge of the product and slide the integration foot under the levelling foot. Push the produc...

Align Refrigerator in cupboardSlide the product toward the opening side of the cupboard. The integrated foot should touch the cupboard wall. This will set a 20mm ( 3 / 4 ") gap between cupboard and refrigerator. Adjust the product so it is parallel to the cabinet front to back and side to side. ...

Attach Slide bracket to Refrigerator DoorsAttach the slide bracket to the side of the door opposite to the hinges, 100mm (4") in from the edge. On a two door refrigerator use one slide bracket per door. If integrating a 790 model, we recommend using 2 slide brackets per door - one near the botto...

Attach Slide Bracket to cupboard Doora) Open both cupboard and refrigerator door to 110˚ degrees. (525 Compact models to 90˚) b) Put slide bracket in retainer, 120mm ( 4 3 / 4 ") approx past refrigerator door. (diagram 9). c) Check that screw A (supplied with kit) will not penetrate front surfac...

B A G C D E Measure from surface the refrigerator rests on Model Dim A (mm) Dim B (mm) Dim C* (mm) Dim D (mm) Dim E* (mm) Dim G (mm) If ‘0’ overlay doors are used add 30mm to dimension ‘A’ and ‘B’ Specification subject to change without notice e415H 735 730 1716 1240 480 20 Dimensions Diagram 11 Hum...

Remove handle and discard Fit Diagram 12 Diagram 13 4 12 1 1 1 Additional humidity drawer kit Part No. 880800 Part Quantity Description Part no. Bracket Screw E: (#6X 1 / 2 PAN PH) Endcap Blank RH white Endcap Blank LH white Endcap Outer 635 white 880801 SP0008 883715 883716 883670 Humidity Drawer I...

Assembly instructions for ‘H’ drawer built-in kits • The “H” drawer of this type of refrigerator is attached to the outer door panel of the built-in cabinet by means of four angle brackets attached to the back of the outer drawer front. 1. Fit the Refrigerator as previously instructed into the built...