Fisher & Paykel CG755 - Manuals

5 Important safety precautions Operation Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the appliance without danger to themselves or their surr...

6 Installation instructions Cooktop and cutout dimensions A B C D Gas connection is made at the right rear CG755: Electrical connection is made at the left rear CG604: Electrical connection is made at the right rear G F E Cooktop and cutout dimensions (mm) C G604 C G755 A overall width of cooktop 60...

7 Installation instructions Clearances Clearances (mm) C G604 C G755 A minimum clearance from rear edge of cutout to: nearest combustible surface 60 60 B minimum clearance from glass surface to: rangehood 650 650 C minimum clearance from side edges of cutout to: nearest combustible surface 220 235 D...

8 The appliance may be installed in a suitable room in accordance with the current laws in force. The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi-commercial or communal environment. Installing the appliance in any of the above environmen...

9 Installation instructions Ventilation requirements (all countries except UK) Providing adequate ventilation The installer must refer to the current local regulations. The room accommodating the gas cooktop must have adequate natural draught to allow combustion of the gas. The flow of air must come...

10 Ventilation requirements (United Kingdom only) The appliance should be installed in a room or space with an air supply in accordance with BS 5440:2 2000. For rooms with a volume of less than 5 m 3 , permanent ventilation through a free area of at least 100 cm 2 will be required. For rooms with a ...

11 Installation instructions Fastening the cooktop to the bench 1 Turn the cooktop upside down and place it on a soft surface. 2 Spread the seal around the edges, with the adhesive side facing down. 3 Mount the supplied front and rear clamps (F and R) and screws (S) onto the cooktop, as shown (witho...

12 Installation instructions Gas installation requirements This appliance is adjusted at the factory for use on Natural gas. To use it on LPG, it will first have to be converted. If the LPG conversion kit is not supplied with the appliance, contact your nearest Authorised Service Centre. Installatio...

13 Installation instructions Connecting the cooktop to the gas supply The gas connection fitting (Fig. 5) is made up of: the floating nut the elbow the washer. If using a flexible hose, make sure it does not come into contact with moving parts. To maintain the minimum 30 mm clearance requirement bel...

14 Installation instructions When connecting the cooktop to the gas supply with rigid pipes or a flexible hose (which must comply with BS 669 in the UK), make sure that: you use rigid pipes or a flexible hose compliant with applicable local regulations. The flexible hose shall be of the correct cons...

15 Installation instructions Leak-testing and flame-testing the cooktop 1 After connecting the gas supply, check the piping and connections for leaks as required by local regulations. The presence of bubbles indicates a leak. Tighten or replace connections as appropriate, then re-check for leaks. Im...

16 Installation instructions Table f or the choic e of injec tors Cat: II 2H3+ Gas type: G20 Auxiliary (A) 1,00 0,30 72 (X) Semi-rapid (SR) 1,75 0,45 97 (Z) Rapid (R) 3,00 0,75 115 (Y) Triple ring (TR) 3,50 1,50 135 (T) BURNERS NOMINAL POWER (H S - kW) REDUCED POWER (H S - kW) Ø INJECTOR (1/100 mm) ...

17 Installation instructions Converting the cooktop to a different gas type Important! Only a suitably qualified and registered person may convert the cooktop to a different gas type. To convert from one gas type to another, you need to replace the injectors, and thenadjust the minimum gas rate sett...

18 Installation instructions Electrical connection Important! This appliance must be earthed. Installation must be carried out according to the manufacturer’s instructions. Incorrect installation may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsi...

19 Installation instructions For the United Kingdom and the Republic of Ireland only: The appliance must be connected to a 220-240V~50 Hz supply by means of a suitably earthed three-pin socket and should be protected by a 3A fuse in the plug. If the appliance is supplied without a plug, fit a rewire...

20 Installation instructions Final checklist TO BE COMPLETED BY THE INSTALLER Have you installed the clamps? Have you clamped the cooktop to the bench securely? Have you used the supplied washers? Have you leak-tested all connections? Is the cooktop set for the correct gas type and pressure? Are the...

22 Introduction About your new cooktop Thank you for buying a Fisher & Paykel gas cooktop. Once it is installed and ready to use, you will want to know everything about it to make sure you get excellent results right from the start.This guide introduces you to all its special features. We recomm...

23 Gas burners The knob (Fig. 13) controls the flow of gas through the safety valve. Using your cooktop Fig.13 Burner knob Never cook or leave the knob between maximum and O (off ). You can choose to cook at any heat between minimum and maximum OFF (closed valve) Minimum Maximum Using the burners 1 ...

24 Using your cooktop If the flame is irregular If the flame is yellow or irregular, check that the burner parts, including the burner cap, are: clean and dry positioned correctly as shown in the ‘Care and cleaning’ section. See also ‘Troubleshooting’. Fig.15 Cleaning the ignitor and probe If a burn...

25 Using your cooktop Burners Minimum Maximum Auxiliary 12 cm 14 cm Semi-rapid 16 cm 20cm*, 24 cm Rapid 24 cm 26 cm Triple-ring wok (five-burner models only) 26 cm 28 cm Maximum diameter for woks 36 cm * Front semi-rapid burner on four burner models only Matching cookware to burner Use flat-bottomed...

26 Care and cleaning Important! Before any cleaning or maintenance, make sure that: all the burners are turned off the cooktop is disconnected from the power supply all parts of the cooktop are cool enough to safely touch. Important! For safety reasons, never unscrew the burner plate fixing screws. ...

27 Care and cleaning Cleaning chart What? Soiling examples How? Important! Stainless steel strip fingerprints food stains 1 Wipe with a clean damp cloth. 2 Dry with a soft, lint- free cloth. Regular use of a stainless steel polish will reduce fingerprints and other marks Follow the manufacturer’s in...

29 Care and cleaning Replacing the triple-ring wok burner and pan support (five-burner models only) Ensure that the burner and pan support assembly is: unable to rotate stable and level correctly aligned. Fig. 21 Ensure the burner and pan support are replaced correctly Use the correct pan support on...

30 Troubleshooting Problem Possible solutions A burner does not light Check the cooktop is plugged in and the electricity is switched on.Check the gas supply valve is turned on and the supply to the house is working. You should hear the gas when you turn a burner on.If you use bottled gas, check the...

31 Warranty and service Before you call for service or assistance ... Check the things you can do yourself. Refer to the installation instructions and your user guide and check that: 1 your product is correctly installed 2 you are familiar with its normal operation. If after checking these points yo...