Fiesta EZT40050-P484 - Manuals

Page 2 - casquillo del cubo

2 Install Wheels. Wheel Tank Support Place Axle Through Wheel Center.Push Axle into Clip Until it Snaps in Place. Install Leg Extensions.Position LEFT LEG ASSEMBLYas Shown and Insert Leg Extensions.Turn Assembly Over and Tap LegExtensions Against a Hard Surface(If Necessary) Until Fully Seated. 12 A...

Page 3 - Install Cross Member as Shown.; Abrazadera Del Canal Instalada

Install Cross Member as Shown. Cross Member Channel Clamp Wing Nut Carriage Bolt Cup Washer Wing Nut Left End Bottom Support 1/4" - 20 X 2-1/2" Carriage Bolt Cup Washer 1/4" Wing Nut Channel Clamp Installed Abrazadera Del Canal Instalada Instale a miembro cruzado según lo mostrado. perno...

Page 4 - Instalar el Panel Delantero; Install Back Support; Instale detrás la ayuda

4 1/4-20 J BOLT 1/4-20 Wing Nut 1/4 PERNO De J 1/4-20 la muez del ala Install Front Panel. Instalar el Panel Delantero Install Back Support Instale detrás la ayuda

Page 5 - La Nuez del ala; Install Base Casting and Grease Cup Clip; Grease Cup Clip; Instale el bastidor bajo y engrase el clip de la taza

5 1/4" Wing Nut La Nuez del ala Install Base Casting and Grease Cup Clip Grease Cup Clip Base Casting Soup Can not Sup- plied with Grill. Instale el bastidor bajo y engrase el clip de la taza bastidor bajo La sopa no puede pro-visto de la parrilla. clip de la taza

Page 6 - Instalar hornilla de la H según lo mostrado.; Install H Burner as Shown.

6 Instalar hornilla de la H según lo mostrado. Install H Burner as Shown. "H" Burner Hornilla De "H"

Page 7 - Instalación de la consola al ensamblaje de la pierna.

Attach Screw as Shown. Install Console as Shown. Installation of Console to Leg Assembly. Enlarged View of Burner Installed. Instale consola según lo mostrado. Note: Be Sure Valves Fit into Burner Tubes During Console Instal-lation. Nota: Este seguro que las válvu-las encaje bien durante la insta-la...

Page 8 - Install Side Shelf and Flame Trap.

8 Install Side Shelf and Flame Trap. Slide Shelf onto Legs. Tabs on Underside of Shelf will Snap into Notches as Shown. Instalar el desvío lateral del estante y de llama. Resbale el estante sobre las piernas. Las tabulacio-nes en el superﬁcie inferior del estante se encajarán a presión hacia muescas...

Page 10 - Note: Hook Side Burner Electrode Wire to Igniter; Instalar la conexión lateral

Install Side Burner. #10-24 Wing Nut Note: Hook Side Burner Electrode Wire to Igniter Wire. (Rear Side of Console) Instalar la conexión lateral 10 Nota: Conecta el electrodo del quemador del lado al el alambre de encender. (Consola de atras)

Page 11 - Before proceeding with the following steps, ensure you; USE; located at the front of this manual. The; USE AND; Insert Tank Bracket into Slot, Rotate 90 Degrees. Slide Down Over

11 IMPORTANT: Ensure hose assembly does not contact the casting, or any other parts which will get hot. WARNING: Before proceeding with the following steps, ensure you have read L.P. Gas Cylinder Hose and Regulator sections of the USE AND CARE INSTRUCTIONS located at the front of this manual. The L....

Page 12 - Replacement Part; Piezas De Recambio

SMAR T BAR barra elegante SP46-9P INSER T SM68-6 SMAR T ROD SP 135-3 COOKING GRID SP8B-20 IGNIT OR CLIP Replacement Part s Piezas De Recambio clip del ignitor cocinando la rejilla barra elegante separador SP 4-15 HAIR PIN el alfiler del cabello "T" LID la tapa t HANDLE WING NUT el esidero la...

Page 13 - TANK NOT

SM 36-2P BASE la base SP 52-12 SIDE BURNER hornilla lateral SP 9-7 S.B. KNOB SP30-16 PUSH PIN SP47-9P SIDE BURNER TRIM SP 55-18 AXLE SP30-15 AXLE CLIP SP 17-22 WHEEL SP 28A-9P FRONT P ANEL GG20-27 T ANK SP 24-33 LEG EXTENSION SM5061-42P R.H. LADDER ASSEMBL Y SM 56-8P CHANNEL SP 25-16 WING NUT SM 87-...