Fiesta EZA34545-P306 - Manuals

Page 2 - Ayuda del Tanque

Install Wheels. Axle Wheel Wheel Axle·rbol Tank Support Place Axle Through Wheel Center.Push Axle into Clip Until it Snaps in Place. Leg Extensions Install Leg Extensions.Position LEFT LEG ASSEMBLYas Shown and Insert Leg Extensions.Turn Assembly Over and Tap LegExtensions Against a Hard Surface(If N...

Page 3 - Install Cross Member as Shown.

Install Cross Member as Shown. Cross Member Channel Clamp Wing Nut Carriage Bolt Cup Washer Wing Nut Left End Bottom Support 1/4" - 20 X 2-1/2" Carriage Bolt Cup Washer 1/4" Wing Nut Channel Clamp InstalledAbrazadera Del Canal Instalada Instale a miembro cruzado según lo mostrado. perno ...

Page 4 - Instalar el Panel Delantero.; Install Back Support; Instale Detrás La Ayuda

#10-24 X 1-3/4" Carriage Bolt #10-24 Wing Nut #10-24 X 1-3/4" el cerrojo del coche #10-24 la muez del ala Install Front Panel. Instalar el Panel Delantero. Install Back Support Instale Detrás La Ayuda 4

Page 5 - Instalar el bastidor bajo y engrase el clip de la taza

1/4" Wing NutLa Nuez del ala Install Base Casting and Grease Cup Clip Grease Cup Clip Base Casting Soup Can notSupplied with Grill. Instalar el bastidor bajo y engrase el clip de la taza clip de la taza bastidor bajo La sopa no puedeprovisto de la parrilla. 5

Page 6 - Install Bar Burner as Shown.; Instale hornilla de la barra según lo

Install Bar Burner as Shown. Instale hornilla de la barra según lo mostrado. 6

Page 7 - Instalación de la consola al ensamblaje de la pierna.

Attach Screw as Shown. Install Console as Shown. Installation of Console to Leg Assembly. Enlarged View of Burner Installed. Instale consolasegún lo mostrado. Note: Be Sure Valves Fitinto Burner Tubes DuringConsole Installation. Nota: Este seguro que lasválvulas encaje bien durante lainstalación de ...

Page 8 - Instalar el desvío lateral del estante y de llama.; Install Side Shelf and Flame Trap.

8 Slide Shelf onto Legs.Tabs on Underside ofShelf will Snap intoNotches as Shown. Resbale el estante sobrelas piernas. Lastabulaciones en elsuperficie inferior delestante se encajarán apresión hacia muescassegún lo mostrado. Instalar el desvío lateral del estante y de llama. Install Two Support Rods...

Page 12 - Ensure hose; Before proceeding with the following steps, ensure you; Regulator Connection Facing Front.

12 IMPORTANT: Ensure hose assembly does not contact the casting,or any other parts which will get hot. WARNING: Before proceeding with the following steps, ensure you have read L.P. Gas Cylinder Hose and Regulator sections of the USEAND CARE INSTRUCTIONS located at the front of this manual. TheL.P. ...

Page 14 - ANK; clip del; JUMPER WIRE

SM 34-2P BA S E SP 52-12 SIDE B URNER SP 9-7 S.B. KNOB SP30-16 PUSH PIN SP47-9P SIDE B URNER TRIM SP 55-18 AXLE SP 30-15 AXLE CLIP SP 19-22PF WHEEL SP 29-9P FR ONT P ANEL GG20-27 T ANK SP 23-33 LEG EXTENSION SM5061-42P R.H. LADDER ASSEMBL Y SM 57-8P CHANNEL SP 25-16 WING NUT SM 87-6 CHANNEL CLAMP SM...