Page 2 - Precautions; Safety Instructions • English; Instrucciones de seguridad • Español; Extron’s Warranty
Precautions This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may pres...
Page 3 - 注意; FCC Class A Notice
安全须知 • 中文 这个符号提示用户该设备用户手册中有重要的操作和维护说明。 这个符号警告用户该设备机壳内有暴 露的危险电压,有触电危险。 注意 阅读说明书 • 用 户 使 用 该 设 备 前 必 须 阅 读 并 理 解 所 有 安 全 和 使 用 说 明 。 保存说明书 • 用户应保存安全说明书以备将来使 用。 遵守警告 • 用户应遵守产品和用户指南上的所有安 全和操作说明。 避免追加 • 不要使用该产品厂商没有推荐的工具或 追加设备,以避免危险。 警告 电源 • 该 设 备 只 能 使 用 产 品 上 标 明 的 电 源 。 设 备 必 须 使 用 有 地 线 的 供 电 系 统 供 电 ...
Page 4 - SW DVI A Series • Table of Contents; Table of Contents; Chapter One • Introduction
i SW DVI A Series • Table of Contents Table of Contents Chapter One • Introduction ................................................... 1-1 About this Manual .................................................................... 1-2 About the SW DVI A Series ...............................................
Page 5 - Table of Contents, cont’d; SW DVI A Series; Chapter Four • SIS Configuration and Control; Switcher-initiated messages; Using the Command/Response Table; Symbol definitions; Appendix A • Specifications, Part Numbers,; Specifications; Chapter One; Introduction; About this Manual
ii SW DVI A Series • Table of Contents Table of Contents, cont’d SW DVI A Series Chapter Four • SIS Configuration and Control ......... 4-1 Host-to-Switcher Communications ...................................... 4-2 Switcher-initiated messages ................................................. 4-2 Err...
Page 6 - SW DVI A Series • Introduction; The SW DVI A Series switchers are not compatible with; Features
SW DVI A Series • Introduction Introduction SW DVI A Series • Introduction 1-3 1-2 Independent input equalization — High and low equalization levels for each input can be selected via the Input EQ DIP switches on the front panel. This reduces the need for additional signal conditioning equipment by ...
Page 7 - Chapter Two; Installation; Application Diagram; The following diagram provides an example of how an; Connection diagram for an SW4 DVI A switcher
SW DVI A Series • Introduction Introduction, cont’d 1-4 SW DVI A Series 2 Chapter Two Installation Installation Overview Mounting the SW DVI A Series Rear Panel Features Wiring the Power Connector DVI-I Video Connectors Audio Connectors Wiring the Remote/Autoswitching Connector Application Diagram T...
Page 8 - SW DVI A Series • Installation; Installation Overview; Tabletop use; UL rack mounting guidelines
SW DVI A Series • Installation Installation SW DVI A Series • Installation 2-2 2-3 Installation Overview To install and set up the SW2/SW4 switcher, 1 Mount the switcher on a rack shelf or furniture, if desired. 2 Connect input source(s) to one or more SW2/SW4 video input connectors. 3 Connect an ou...
Page 9 - HalfRackVersaToolsStandardShelf; Back of the rack mounting; HalfRackVersaToolsShelf
SW DVI A Series • Installation Installation, cont’d 2-4 SW DVI A Series • Installation 2-5 Use 2 mounting holes onopposite corners. (2) 4-40 x 3/16"Screws 1U Universal Rack Shelf Front falsefaceplateuses 2screws. HalfRackVersaToolsStandardShelf 1/2 Rack Width Front FalseFaceplate 3 2 4 Mounting ...
Page 10 - Furniture mounting; Preparing the SW2/SW4 for under-desk mounting
SW DVI A Series • Installation Installation, cont’d 2-6 SW DVI A Series • Installation 2-7 Furniture mounting To mount the SW DVI A switcher under a desk, table, or podium, use the optional VersaTools MBU 123 Mini Under-Desk Mounting Kit (part #70-212-01), as follows: 1 . If rubber feet were previou...
Page 11 - Rear Panel Features; SW2 DVI A rear panel; SW4 DVI A rear panel
SW DVI A Series • Installation Installation, cont’d 2-8 SW DVI A Series • Installation 2-9 b Video output connector — Connect a DVI-D display device to this female DVI-I connector. Each time a display is powered on and connected to the switcher ’s output connector, the EDID information is read from ...
Page 12 - DVI-I Video Connectors; Audio Connectors; Audio input; mm Stereo Plug Connector; Input connector pinout for unbalanced stereo audio; Wiring the Power Connector; Power connector wiring
SW DVI A Series • Installation Installation, cont’d 2-10 SW DVI A Series • Installation 2-11 DVI-I Video Connectors The DVI-I video input and output connectors have the following pin configuration: 8 CEC control 16 Hot plug 24 TMDS clock– detector Pin Signal Pin Signal Pin Signal 1 TMDS data 2– 9 TM...
Page 13 - RS-232/autoswitch connector pin assignments; Enabling autoswitching; Wiring the audio output connector; Wiring the Remote/Autoswitching Connector; UC cable pin assignment color codes
SW DVI A Series • Installation Installation, cont’d 2-12 SW DVI A Series • Installation 2-13 1 . Wire the RS-232 cable to the five-pole captive screw plug, provided with the SW2/SW4, as described below. Connect only the red, orange, and green wires in the cable; and use only the first three pins on ...
Page 14 - Chapter Three; Operation; Front Panel Features
SW DVI A Series • Installation Installation, cont’d 2-14 SW DVI A Series To enable autoswitching, 1 . Cut a small piece of wire to use as a jumper. 2 . Insert the ends of the wire into pin holes 4 and 5 of the provided 5-pole captive screw plug, connecting pins 4 and 5 together. (See the figure at r...
Page 15 - SW DVI A Series • Operation; Operations; Powering on the switcher; The EDID information is also read and stored again; Selecting an input; SW4 DVI A front panel; Auto Switch Active LED
SW DVI A Series • Operation Operation SW DVI A Series • Operation 3-2 3-3 Operations Powering on the switcher To power on the SW2/SW4, 1 . Connect all input and output devices to the switcher ’s rear panel connectors. (See chapter 2, “Installation,” for information on the rear panel connections.) 2 ...
Page 16 - Using the IR 102 remote control; Area for remote signal reception; Remote control buttons; Locking IR remote access; off; Enabling front panel lockout (executive mode); Setting executive mode
SW DVI A Series • Operation Operation, cont’d 3-4 SW DVI A Series • Operation 3-5 Using the IR 102 remote control The hand-held IR 102 Remote Control lets you remotely perform functions that are also available through the front panel buttons and SIS commands. The IR receiver port on the front panel ...
Page 17 - Setting equalization for input sources; Resetting restores the EDID to a resolution of 1024x768; Updating Firmware; Updates to the SW DVI A Series firmware are made available; Downloading the firmware; Firmware link on the Download tab; Download; Download link for SW DVI A firmware
SW DVI A Series • Operation Operation, cont’d 3-6 SW DVI A Series • Operation 3-7 Setting equalization for input sources High and low EQ levels for each input can be selected via the Input EQ DIP switches on the front panel. Setting these switches to High (up) compensates for a degraded/poor quality...
Page 18 - Loading the firmware to the switcher; Although the screen also has a TCP/IP tab, the; OK; The firmware file must have a .s19 extension.
SW DVI A Series • Operation Operation, cont’d 3-8 SW DVI A Series • Operation 3-9 Loading the firmware to the switcher To load a new version of firmware to your SW2/SW4, use the Firmware Loader software. Your computer ’s serial port must be connected to the first three pins on the switcher ’s Remote...
Page 19 - Upload; Chapter Four; SIS Configuration and Control
SW DVI A Series • Operation Operation, cont’d 3-10 SW DVI A Series 9 . On the Choose Firmware File window, double-click on the new firmware file to open it. The Choose Firmware File window closes, and the path to the selected firmware file is displayed in the “Select a firmware file” field on the fi...
Page 20 - SW DVI A Series • SIS Configuration and Control; Unless otherwise indicated, commands are; This message is displayed only at power-up.; Error responses
SW DVI A Series • SIS Configuration and Control SIS Configuration and Control SW DVI A Series • SIS Configuration and Control 4-2 4-3 Using the Command/Response Table The command/response table on the following pages lists valid ASCII and hexadecimal command codes, the switcher ’s responses to the h...
Page 21 - SIS Configuration and Control, cont’d; esponse table for SIS commands
SW DVI A Series • SIS Configuration and Control SIS Configuration and Control, cont’d 4-4 SW DVI A Series • SIS Configuration and Control 4-5 Command ASCII Command (host to unit) Response (unit to host) Additional description Input selection Select video and audio input X! ! In X! All ] Select both ...
Page 22 - Appendix A; Accessories
SW DVI A Series • SIS Configuration and Control SIS Configuration and Control, cont’d 4-6 SW DVI A Series A Appendix A Specifications, Part Numbers, Accessories Specifications Included Parts Accessories Cables and Adapters
Page 23 - Specifications, Part Numbers, Accessories; SW DVI A Series • Specifications, Part Numbers, Accessories; Contact closure pin configurations; input
SW DVI A Series • Specifications, Part Numbers, Accessories Specifications, Part Numbers, Accessories SW DVI A Series • Specifications, Part Numbers, Accessories A-2 A-3 Audio input Number/signal type ..................... 2 or 4 stereo, unbalancedConnectors ..................................... (2 ...
Page 24 - Included Parts; Included parts; or; SW DVI A Series User's Manual; Specifications are subject to change without notice.
SW DVI A Series • Specifications, Part Numbers, Accessories Specifications, Part Numbers, Accessories, cont’d SW DVI A Series • Specifications, Part Numbers, Accessories A-4 A-5 Included Parts These items are included in each order for an SW DVI A Series switcher: Included parts Part numbers SW2 DVI...
Page 25 - Cables and Adapters; Cables
SW DVI A Series • Specifications, Part Numbers, Accessories Specifications, Part Numbers, Accessories, cont’d A-6 Cables and Adapters The following table lists cables and adapters that are available for the SW DVI A Series. For a complete listing of cables, visit the Extron Web site at www.extron.co...