Extron DTP DVI 301 - Manuals

Extron DTP DVI 301 – Manual in PDF format online.

Manuals:

Manual

Manual Extron DTP DVI 301

Summary

Page 2 - Instrucciones de seguridad • Español; 安全须知; 注意

This symbol is intended to alert the user of important operating and mainte-nance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may present a risk ...

Page 3 - FCC Class A Notice; This device may not cause harmful interference.; click here

FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interferen...

Conventions Used in this Guide In this user guide, the following are used: CAUTION: A caution indicates a potential hazard to equipment or data. NOTE: A note draws attention to important information. TIP: A tip provides a suggestion to make working with the application easier. WARNING: A warning war...

Page 5 - Contents; About this Guide; DTP DVI 301 • Contents

Contents Introduction ............................................ 1 About this Guide ............................................. 1 About the DTP DVI 301 Tx/Rx Transmitter and Receiver ................................................... 1 Transmission Distance .................................. 2T...

Page 7 - Introduction; ) extends the usable; ON; Extron; Typical Transmitter and Receiver Application; DTP DVI 301 • Introduction

Introduction • About this Guide • About the DTP DVI 301 Transmitter and Receiver • Features About this Guide This guide describes the Extron DTP DVI 301 Long Distance Digital Visual Interface (DVI) Twisted Pair Extender, which consists of a DTP DVI 301 Tx transmitter and a DTP DVI 301 Rx receiver. T...

Page 8 - TP Cable Advantages; not; AV UTP cable or; Control Communications; Features; Long distance transmission; — Bidirectional RS-232 and IR control signals; Remote powering of transmitter or receiver

The transmitter is shipped with a single external desktop 12 VDC power supply that accepts 100 to 240 VAC, 50-60 Hz input. A single power supply connected to either the transmitter or the receiver can power both units through the TP cable that carries DVI video. TP Cable Advantages Twisted pair cabl...

Page 9 - Mounting the Transmitter or Receiver; Transmitter Connections; Front; DTP DVI 301 Tx Connectors; — Connect a DVI cable between this port and the DVI output; Local Output connector; If desired, connect a DVI monitor for local monitoring of; DTP DVI 301 • Installation and Operation

Installation and Operation This section describes the installation and the operation of the DTP DVI 301 Tx/Rx Extender, including: • Mounting the Transmitter or Receiver • Connections • Operation Mounting the Transmitter or Receiver CAUTION: Installation and service must be performed by authorized p...

Page 10 - that is embedded in the DVI input.; mm Stereo Plug Connector; — Ensure the free end of this cable is; only; — Plug the included external 12 VDC power supply into; or

c Audio connector — If desired, plug an analog audio input into the transmitter via this stereo mini jack connector. NOTES: • The analog audio input on this connector is in addition to the digital audio that is embedded in the DVI input. • See the figure at right to identify the tip, ring, and sleev...

Page 11 - Receiver Connections; Rea; DTP DVI 301 Rx Connectors; item; Embedded audio; Signal LED; — This LED lights when the unit is receiving a TMDS clock signal on; Link LED; — Connect a display with a DVI input to display the; DVI connector pin assignments

Receiver Connections . Front Rear L R OUTPUTS DVI-D AUDIO DTP DVI 301 Rx Rea R r F Fro t nt Rx Tx RS-232 IR Rx Tx POWER 12V 0.7 A MAX IN ANALOG AUDIO SIG LINK DTP IN 10 9 11 8 7 Figure 3. DTP DVI 301 Rx Connectors g DTP and Analog Audio Input RJ-45 connectors — Connect one end of the one or two sepa...

Page 12 - Audio output connector; Unbalanced Stereo Output; Captive Screw Connector Wiring for Stereo Audio Output; DO NOT; RS-232 and IR connector

i Audio output connector — This 5-pole, 3.5 mm captive screw connector outputs the transmitted, unamplified, line level analog audio. Connect an audio device, such as an audio amplifier or powered speakers.See figure 4 to properly wire a captive screw output connector. Use the supplied tie-wrap to s...

Page 13 - Pin Assignments and Wiring; Figure; DVI Connector

Pin Assignments and Wiring DVI connector pin assignments Figure 5 defines the pinout for the DVI connector. Pin Signal 1 TMDS data 2– TMDS data 2+ TMDS data 1– TMDS data 1+ DDC clock +5 V power DDC data TMDS clock+ Ground (+5 V) CEC control* TMDS clock– Hot Plug Detect TMDS data 0– TMDS data 0+ Spar...

Page 14 - TP cable termination; Connector; TP Cable Termination; use Extron UTP23SF-4 Enhanced Skew-FreeTM AV UTP cable or; powered

TP cable termination Figure 6 details the recommended termination of TP cables with RJ-45 connectors in accordance with either the TIA/EIA T 568A or the TIA/EIA T 568B wiring standard. 5 Pin 1 23 678 4 Wire color White-green Green White-orange White-blue Orange White-brown Brown Blue Wire color Whit...

Page 15 - Terminating shielded cable; Terminate the STP cable as follows:; Peeling Back the Cable Shielding; the beginning of the tape; Wrapping the Shielded Tape; Crimped RJ-45 Connector

Terminating shielded cable The Tx and Rx each include two shielded RJ-45 connectors and a length of self-adhesive shielded tape that you can use to make the STP cables that connect the transmitter and receiver. NOTE: Extron supplies the connectors and the shielded tape. You must supply the CAT 5e, C...

Page 16 - Power supply wiring; SECTION A–A; Power Connector Wiring

Power supply wiring NOTES: • Only one power supply is required. A single power supply connected to either unit in the pair powers both units. • A power supply is included with each transmitter. Figure 10 shows how to wire the connector. Use the supplied tie-wrap to strap the power cord to the extend...

Page 17 - RS-232 and IR connector wiring; RS-232 Connector Wiring; Operation; Rear; Power Indicator and DIP Switches; This rear panel switch selects either the remote or local DVI

RS-232 and IR connector wiring Figure 11 shows how to wire the RS-232 connector. Ground Receive pin on connected unit Transmit pin on connected unit Connected RS-232and IR Device Pins Tx/Rx Pins Receive pin on connected unit Transmit pin on connected unit Rx Tx RS-232 IR Rx Tx Figure 11. RS-232 Conn...

Page 18 - Specifications; NOTES; with twisted pair cables linking the transmitter and receiver.; Video; RGB and YCbCr digital video; Video input and loop-through — transmitter; Gain; DTP DVI 301 • Reference Information

Reference Information This section discusses the specifications, part numbers, and accessories for the DTP DVI 301 Tx/Rx transmitter and receiver. Topics that are covered include: • Specifications • Part Numbers and Accessories • Mounting the Transmitter or Receiver Specifications NOTES : • This pro...

Page 19 - Serial control port input/output; General; receiver or transmitter on the other end of the CAT 5/5e/6 cable.

Audio input Number/signal type ........................ 1 PC level stereo, unbalancedConnectors .................................... (1) 3.5 mm stereo jack, 2 channel; tip (L), ring (R), sleeve (ground) Impedance ..................................... >10k ohms, DC coupledNominal level ..............

Page 20 - Specifications are subject to change without notice.

Enclosure dimensions Transmitter .............................. 1.0" H x 4.3" W x 3.0" D (quarter rack wide) (2.5 cm H x 10.9 cm W x 7.6 cm D) (Depth excludes connectors.) Receiver ................................... 1.0" H x 4.3" W x 6.0" D (quarter rack wide) (2.5 cm H x 10...

Page 21 - Part Numbers and Accessories; Transmitter/Receiver Pair Part Numbers; DTP DVI 301 Tx transmitter; Included Parts; screw connector; Cables and Adapters; nn

Part Numbers and Accessories Transmitter/Receiver Pair Part Numbers NOTE: The Tx/Rx is comprised of the transmitter and receiver pair, which are purchased separately. DTP DVI 301 Model Part Number DTP DVI 301 Tx transmitter 60-1213-12 DTP DVI 301 Rx receiver 60-1213-13 Included Parts These items are...

Page 22 - Mounting Accessories; -inch deep 1U universal rack shelf kit; Tabletop Use

Mounting Accessories Mounting kit Part Number RSF 123 3.5-inch deep 1U rack shelf kit (transmitter only) 60-190-20 RSB 123 3.5-inch deep 1U rack shelf (transmitter only) 60-604-21 RSU 126 6-inch deep 1U universal rack shelf kit 60-190-10 RSB 126 6-inch deep 1U basic rack shelf 60-604-11 RSU 129 9.5-...

Page 23 - Extron Warranty; and Central America:; USA; xtron

Extron Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electronics will, a...