Extron 130xi - Manuals

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Introduction Introduction About this Manual This manual documents three universal interfaces: RGB 130 xi , RGB 134 xi , and RGB 150 xi . Unless otherwise specified, any references to “the interface” shall refer to the features oroperat...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Introduction 2 Chapter Two Controls and Installation Front and Rear Panels Installation RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-1 Front and Rear Panels RGB 150 xi xi xi xi xi front panel features Figure 2-1 — RGB 150 xi xi xi xi xi front panel 1 2-color power/signal LED — lights amber to indicate power On only; lights green to indica...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-2 RGB 150 xi xi xi xi xi rear panel features Figure 2-2 — RGB 150 xi xi xi xi xi rear panel 1 AC power input — standard IEC AC power connector (100 - 240VAC 50/60 Hz) 2 3-position gain/peak switch — unity*; ...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-3 RGB 130 xi xi xi xi xi front panel features Figure 2-3 — RGB 130 xi xi xi xi xi front panel 1 2-color power/signal LED — lights amber to indicate power On only; lights green to indicate power Onwith video ...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation Installation Easy setup procedure Except where noted, the installation procedures for the RGB130 xi , 134 xi , and 150 xi are the same. See “Cabling” in this chapter for more information. 1 If desired, mount t...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation Mounting the interface To mount the interface under a desk or in a podium, do thefollowing: 1. Attach the mounting brackets to the interface usingsix machine screws supplied with the mounting kit(see figure 2-...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation Controls and Installation, cont’d 2-9 To mount the interface through a desk or table, do thefollowing: 1. Attach the mounting brackets to the interface usingfour machine screws and washers (supplied with themo...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-10 Cabling Each interface can connect to the computer or workstation’slocal monitor and to a projector or other display device. The diagrams below show how to connect each of theinterfaces. 1. Connect the co...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation Controls and Installation, cont’d 2-11 Figure 2-13 — RGB 150 xi xi xi xi xi installation 2. Connect the interface cable marked “Video input” tothe computer ’s video output (where the monitor wasoriginally conn...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-12 Connecting audio output Before connecting audio, determine whether your audiosystem is unbalanced or balanced. Then, follow theinstructions below to connect unbalanced audio, or theinstructions for “Balan...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation Controls and Installation, cont’d 2-13 3. Slide the audio cable connector into the audio outputconnector on the interface. Balanced audio To attach the interface to a balanced audio system, do thefollowing: 1....

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-14 Setting the DIP switches DIP switches can be found on the front panel of the RGB150 xi and on the rear panels of the RGB 150 xi , 130 xi , and 134 xi . The switches may be either the rocking type or the s...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-15 devices, such as LCD (liquid crystaldisplay), DLP (digital lamp processing)and plasma displays. OFF — If this switch is set to Off, the interface performs sync processing operations,such as horizontal shi...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation 2-16 Setting internal jumpers The jumpers inside the interface(s) are set at the factory foroptimal use by most systems. However, you can change ajumper setting to meet the needs of a particular system. The us...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation Controls and Installation, cont’d 2-17 pins 1 and 2 connected: pins 2 and 3 connected: Figure 2-16 — Circuit board jumper locations 4. Configure the jumpers. To configure the jumpers,use pliers to pull the jum...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Controls and Installation The jumpers perform the following functions: J20: Sync polarity jumper — This jumper adjusts the output sync polarity. Horizontal (H) and vertical(V) sync output can either follow input syncpolarity, or be for...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Operation A Appendix Specifications Accessories and Part Numbers Mounting Templates RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Appendix Video input Number/type .............................. 1 analog RGBHV, RGBS, RGsB, RsGsBs Connectors .................................... 1 15-pin HD male (150xi) 1 9-pin D male (130xi and 134xi) Nominal level(s) ................

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Appendix A-2 Max. rise/fall time ...................... 3.5 nSPolarity .......................................... RGBHV: when RGBHV is input,polarity follows input; otherwise negativeRGBS, RGsB: ............................ negative Au...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Appendix Appendix, cont’d A-3 Enclosure type ............................. MetalEnclosure dimensions of 130xi and 150xi ........................................................ 1.70" H x 6.35" W x 6.00" D 4.32 cm H x 16.13 ...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Appendix A-4 Accessories and Part Numbers Thunder™ Mounting Kits Under desk mounting kit .................. 70-077-01 Through desk mounting kit .............. 70-077-02 Monitor breakout cables: RGB 130 xi xi xi xi xi and RGB 134 xi xi ...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Appendix Appendix, cont’d A-5 BNC cables BNC-5 3’ HR ........................................ 26-260-15 BNC-5 6’ HR ........................................ 26-260-01 BNC-5 12’ HR ...................................... 26-260-02 BNC-5 ...

RGB 130 xi xi xi xi xi , 134 xi xi xi xi xi , 150 xi xi xi xi xi Appendix FCC Class A Notice Note: This equipment has been tested and found to comply with the limits for aClass A digital device, pursuant to part 15 of the FCC Rules. These limits are designedto provide reasonable protection against h...