Page 2 - CONTENT
2 CONTENT 1 .............................................. Notice 2 .............................................. Installation Requirements 3 .............................................. Installation – Fitting the Rangehood. 4 .............................................. Safety Warning 5 .........
Page 3 - Notice; Contents
3 (1) Notice 1. Thank you for choosing our Slide-out Rangehood. Please read this instruction manual carefully before use. 2. The installation work must be undertaken by a qualified and competent installer in compliance with applicable Australian Standards. 3. Euro Appliances disclaims all liability ...
Page 4 - Installation - Requirements; with the wiring rules.
4 (2) Installation - Requirements Warning: This Rangehood is only suitable for installation indoors in accordance with the following: • Installation must be performed by a qualified competent installer. • If installed above a barbecue, the minimum distance from the cooking grid/plate is 120cm. • If ...
Page 5 - (3) Installation – Fitting the Rangehood
5 (3) Installation – Fitting the Rangehood This Rangehood must be placed at a distance of 65cm minimum from the cooking surface of a cooker/hotplate and 120cm minimum from the cooking surface of a BBQ. 3.1 Fixed to Wall. 3.1.1 Drill 4 x 8mm holes into the wall according to dimensions shown below. 3....
Page 6 - After installation, make sure that the Rangehood is level to avoid
6 Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. 3.2 Fixed to Cupboard. 3.2.1 Drill 6 x 4mm holes into the bottom of the overhead cupboard according to dimensions shown below. Use the two rear holes if possible, if not ...
Page 10 - Cleaning the filters; Method 1: Put the mesh into a sink of clean water, pour on
10 (6) Maintenance 6.1 Cleaning the filters The filter mesh is made of high-density stainless steel. Please do not use corrosive detergent on it. Keeping this filter clean will keep the appliance running correctly. Please strictly follow the guidelines below. Method 1: Put the mesh into a sink of cl...
Page 11 - HSODFHPHQWIURQWUDLO; Replacement Light
6. 5HSODFHPHQWIURQWUDLO 1. Pull out the slide housing,and unscrew 2 screws at the top of the slide housing. 2 . Remove the switch panel,can see there are 4 small screws on the backside of front raill. 3. Unscrew these 4 small screws,that can unload the front rail. 4. Install the front rail which nee...