Euro Appliances EM70UMS - Manuals

Page 3 - Warnings

CAUTION : Warnings Accessible parts may become hot when used with cooking appliances. 3 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instru...

Page 4 - Safety Warning

 The appliance is not intended for use by young children or infirmpersons without supervisions.  Young children should be supervised to ensure they do not play withthe appliance.  Plug the power cord to socket outlet with earthing continuity terminal.    Do not use open flame, or allow oil to ...

Page 5 - Measurement

Measurement 259 A 520 700 900 13 L1 497 677 865 L1 Φ150 256 248 284 (A) 492/672/860 520/700/900 5

Page 7 - Installation; Recirculation mode

Installation Here two venting modes, extraction-air mode and recirculation mode, before installing ， select one mode. Extraction-air mode Recirculation mode 7

Page 9 - Replace the metal Filter.

   Reconnect the wires to the Commands and Light. Replace the metal Filter. Install the air outlet pipe(optional). Installation  Screw the stainless steel frame back into place using thescrews removed as described above. 9

Page 10 - Use; Stop; Mid; Light; High

Use Mid Low Stop Light High Press Stop button, the motor will stop running.  Press the Low (speed) button, the motor runs at low speed.  Press the Mid (speed) button, the motor runs at mid speed.  Press the Light button, the two lighting lamps will come on. Press it again and the lamps will be tu...

Page 11 - Maintenance; Cleaning of the filter

Maintenance Cleaning of the filter    Please do not use abrasive detergent for it will damage the hood.  Make sure that the hood is shut off before cleaning. Removing the metal filter according to Installation (page 7). Put it into a dishwasher with detergent, set the temperature below 60 degree...

Page 12 - Changing the filter

Mainten ance Changing the filter    Remove the metal filter according to Installation (page 7 ). Remove the saturated Activated Charcoal Filter s (optional) , as indicated. Fit the new Charcoal Filters, as indicated. Replace the Metal grease Filter according to Installtion (page 8).  12

Page 13 - Replacing the lamp

Maintenance Replacing the lamp  metal ,  ,   Connect the wires of the new  Push the new and fix it to the hole from outside Push to Max Power Voltage Picture Lamp Cap ILCOS D code Round/ Diameter : 70mm 1.5W DC 12 V —— DSR-1.5-S-70 13

Page 14 - Electrical Diagram; Trouble Shooting

222 Cause Solution Light on, but motor does not work. The blades are blocked. The capacitor is damaged. Replace capacitor. The motor is damaged. Replace motor. The internal wiring of motor is cut off / disconnected. An unpleaseant smell may be produced. Replace motor. Apart from the above mentioned,...

Page 16 - Pronto; 5 Glynburn Road, Glyn

Pronto Service + Support: 1800 440 335 Email: [email protected]HEAD OFFICE 65 Glynburn Road, Glyn d e SA 5070 Ph: 08 8165 1012 www.euroappliances.com.au