Empava EMPV-36REC14 - Manuals

13 Part 2. Installation Installation Instructions The appliance must be installed and connected in accordance with current regulations. After unpacking the appliance, ensure there is no visible damage. If it has been damaged during transit, DO NOT USE, contact where you buy immediately. Selection of...

15 Do not install the cooktop without the foam gasket! The gasket should be attached to the cooktop in the following method: ▪ Remove the protective film from the gasket. ▪ Then attach the gasket to the lower side of the glass, next to the edge. ▪ The gasket must be attached along the entire length ...

16 below diagrams, the mounted clips on the sides can secure your cooktop sturdily. Connecting the cooktop to the mains power supply The power supply should be connected in compliance with the relevant standard, or a single-pole circuit breaker. The appliance has a large power rating and must be con...

18 Part 3. Operation Instructions Ceramic Cooktop Model: EMPV-12REC10 1 1 Control Panel 1. 1800W Cooking Zone 2. 1200W Cooking Zone 3. Glass plate 4. Control panel 1. Cooking Zone selection button 2. Heating level/Timer “ - ” button 3. Heating level/Timer “+” button 4. Child Lock control button 5. S...

23 Induction Cooktop Model: EMPV-30EC04 Control Panel 6 8 9 1. 1500W boost 2000W Cooking Zone 2. 2000W boost 2600W Cooking Zone 3. 3000W boost 3600W Flexi Bridge-Left 4. 2000W boost 2600W Cooking Zone 5. 1500W boost 2000W Cooking Zone 6. 3000W boost 3600W Flexi Bridge -Right 7. Glass plate 8. Contro...

27 Using your Cooktop To start cooking 1. After the cooktop be connected to electricity and power on. Press and hold the ON/OFF control button for about 3 seconds till you hear a “ beep ” to turn the cooktop on. Now the cooktop enters into Standby mode, all heat setting indicators and Timer setting ...

28 To turn off cooktop 1. You can turn the cooking zone off by adjust heat setting to level 0, which indicator shows “ - “ . 2. You can also turn the whole cooktop off by touching the ON/OFF control button. Note: If there is power cut off during cooking, all setting will be cancelled. Note: The cool...

29 Using Booster Function-Induction Cooktop Some of induction cooktop models might have one or several cooking zones which has Booster function. You can use the “ Boost er” function to boost power of relevant cooking zone for a maximum power rating for 5 minutes. This function could reduce the cooki...

30 the pans centered on the cooking zone covering both cross. Active the flexible induction bridge To activate a flexible bridge as a single big zone, first press either of the two cooking zone selection buttons of this flexible area, then press the Flexible bridge control button. When flexible brid...

32 Timer overview Using the Timer as a Minute Minder If you have not selected any cooking zones 1.Touch the timer control button , the number in timer indicator flashing. 2. Then adjust Minute Minder setting follows below: 1) Touch control models: • Set heat setting by touching the or button. • If p...

33 Setting the timer to turn cooking zone off 1. Touch the heating zone selection control button to select the cooking zone you wish to set timer for. 2. Touch the timer control button , the number in timer indicator flashing. 3. Then adjust Timer setting 1) Touch control models: • Set heat setting ...

34 Note: The default setting of minute reminder and timer is 30 minutes. Note: After adjusting, the setting in timer indicator will flashing for 5 seconds and then stop flashing, then the setting be confirmed. Note: The minute reminder and timer can be use at same time, timer indicator shows the low...

35 Power level 1 2 3 4 5 6 7 8 9 Default working timer (hour) 8 8 8 4 4 4 2 2 2 Over-heat Protection A temperature sensor equipped can monitor the temperature inside the cooktop. When an excessive temperature is monitored, the cooktop will auto stop operation. Over-flow Protection For your safety, t...

37 Heat Settings The settings below are guidelines only. The exact setting will depend on factors including your cookware and the amount you are cooking. Experiment with the cooktop to find the settings that best suit you. Heat setting Suitability 1 - 2 • delicate warming for small amounts of food •...

38 Hints and Tips What? How? Important! Everyday soiling on glass (fingerprints, marks, stains left by food or non-sugary spillovers on the glass) 1. Switch off the power supply. 2. Apply a vitro-ceramic glass cleaner while the glass is still warm (but not hot!) 3. Rinse and wipe dry with a clean cl...

39 Maintenance of the Cooktop If you find something goes wrong for your cooktop, before contact the service or where you purchased it, please check whether below: 1. There is no power to the appliance: - Check whether there is a power cut of your department; - Check whether the appliance be connecte...