Emerson W152- Manuals

Page 3 - SPECIFICATIONS

3 Tank Construction Tank Volume Voltage Heating Capacity Element Type Temperature Range Operating Pressure Thermostat Type Power Cord Water Connections Pressure Relief Connection Drain Insulation Overall Dimesions Shipping Weight Bronze 120 volts 1500 watts Replaceable copper/bronze* 110˚F - 170˚F 1...

Page 4 - WHAT YOU SHOULD KNOW BEFORE YOU BEGIN; whenever maintenance adjustment or service is required.

4 An imminently hazardous situation, which, if not avoided, will result in death or serious injury. A potentially hazardous situation, which, if not avoided, could result in death or serious injury. A potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. Thi...

Page 5 - PREPARATION; INSTALLATION PROCESS STARTS HERE; Equipment You May Need:; Adjustable wrench; WHAT YOU NEED TO GET STARTED; Minimum

5 PREPARATION INSTALLATION PROCESS STARTS HERE Ensure power switch located at thefront-top of tank is in off position. Identify location for water heater tank. Check to make sure there is properclearance in front of heater to allowfor draining the tank and for accessto replaceable parts such as thet...

Page 6 - Continue with “Step C” if wall mounting.; MOUNTING THE TANK - W152

34 lbs. ( full tank ) Property Damage: Do not connect the electrical power until the tank is full of water. Failure to comply will burn out the heating elements. 6 2 Ensure wall or cabinet is strongenough to hold the weight of a fullheater. The model W152 tank holds2-1/2 gallons and weights 34 lbs.w...

Page 7 - MOUNTING THE TANK - W154

45 lbs. ( full tank ) 7 The W154 model is designed for floormounting only. Select a spot to mount water heatervertically, with water connection at the top. Water heater must be located within3-1/2 ft. of a grounded 120-voltelectrical outlet. Ensure cabinet floor is strongenough to hold the weight of...

Page 8 - INLET; CONNECTING TO WATER SUPPLY; OUTLET

T & P valve comes included and pre-installed on some InSinkEratormodels. Consult local codes andregulations for proper installation and use of required T & P valve. T & P valve is available through yourInSinkErator dealer. C Locate the cold water inlet identified INLET . Ensure the dip t...

Page 9 - CONNECTING TO ELECTRICAL SUPPLY; FILLING THE TANK; Heater is not to be hard wired.

Personal Damage: Never operate the heater with the cold water inlet valve closed or before filling with water per the filling instructions. Failure to do so will cause damage and can void element warranty. 9 Check all connections to ensure theyare tight and that there are no leaks. Plug 3-1/2 ft. wa...

Page 11 - CARE AND USE; SEASONAL STORAGE/DRAINAGE; A D J U S T I N G T H E T H E R M O S TAT; W H AT T O D O I F S O M E T H I N G G O E S W R O N G

11 CARE AND USE Anytime the water heater is not used for extendedperiods of time, unplug and drain unit. If it is belowfreezing you will need to unplug the unit and drain it. Disconnect power from unit. Turn on “hot” faucet until water runs cool. Shut off cold water supply to heater. Leave hot fauce...

Page 12 - -year warranty on bronze tank; Full Residential Water Heater Warranty; Conditions and Exceptions.; Disclaimer and Exclusions.; WARRANTY INFORMATION

12 Water Heater: 1-year warranty Tank: 5-year warranty on bronze tank Full Residential Water Heater Warranty Full One-Year Warranty. InSinkErator warrants that the water heater will be free from defects in material or workmanship for a period of one (1) year after date of original installation. Ifdu...

Page 13 - Limited Residential Water Heater Warranty; -Year Limited Warranty Against Tank Leakage.

13 Limited Residential Water Heater Warranty 5-Year Limited Warranty Against Tank Leakage. InSinkErator warrants that the bronze tank in your InSinkErator water heat will not leak due to defects in material or workmanship for a periodof five (5) years after date of original installation. If during t...

Page 14 - If you are still experiencing trouble call the AnswerLine; If the heater stops working:; Relief Valve Operation:; TROUBLESHOOTING

14 If you are still experiencing trouble call the AnswerLine ™ 1-800-558-5700. Please read Troubleshooting Guide and/or visit www.insinkerator.com before calling AnswerLine ™ Always remove the power cord from its receptacle before servicing the heater. If the heater stops working: Check the circuit ...

Page 15 - WIRING DIAGRAM

1 1 2 2 4 3 HIGH LIMIT SINGLE THROW THERMOSTAT ELEMENT BLACK (HOT) WHITE (NEUTRAL) 3 WIRE POWER CORD 110-120 VAC IMPORTANT: WHITE SIDE OF CORD TO THIS TERMINAL 10-1/2'' 20-5/8''(W-154) 13-1/2'' (W-152) 10-1/4'' 3-1/8'' 1-1/2'' T & P VALVE BOSS 3/4'' NPT FEMALE HOT OUTLET (1/2'' NPT FEMALE) 1 1 2...