Emerson I-0320 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS

(I-0320--.doc/2) 2 TABLE OF CONTENTS I INTRODUCTION ........................................................................................................................................... 4 II MULTIPORT SPECIFICATIONS .................................................................................

Page 3 - OBSERVE ALL WARNING DECALS AND TAGS; Wrench sizes for Multiport flanges:

(I-0320--.doc/3) 3 OBSERVE ALL WARNING DECALS AND TAGS MINIMUM TOOLS REQUIRED: A torque wrench, socket wrench, and allen head wrenches are required to install the Multiport and Actuator assembly. MULTIPORT SIZE NPS 2” NPS 3” ANSI 600 NPS 3” ANSI 900/1500 NPS 4” ANSI 600 NPS 4” ANSI 900 BONNET NUT SO...

Page 6 - Check for external physical damage.; IIIB

(I-0320--.doc/6) 6 III MULTIPORT INSTALLATION Before installing the unit, observe all warning tags and: 1. Check for external physical damage. 2. Check for any visible leakage of gear oil from the speed reducer (426). 3. Visually inspect the inside of the multiport through the group outlet port chec...

Page 7 - ELECTRONIC

(I-0320--.doc/7) 7 with the #6 well connection. This allows for the installation of the connector pin. Note that installing the pin may require electrical power so that the upper section of the connector can be rotated to align the bolt hole. 2. Install the lower section of the connector onto the st...

Page 8 - Make sure the oil in the speed reducer (426) is at the indicated level.; MULTIPORT ASSEMBLY; Visually inspect all internal and external surfaces and threads.

(I-0320--.doc/8) 8 2. Controller address (I-0168 Section J). 3. Control room MODBUS RTU operation (I-0168 Section D). 4. Installation and use of Bettis Multiport Electronic Controller software on laptop PC. IV MULTIPORT MAINTENANCE Refer to the typical multiport assembly drawing AB0461 on page 14 an...

Page 12 - Tighten all mounting bolts and nuts

(I-0320--.doc/12) 12 NOTE: An index mark on one flat on the square end of the plug (130) indicates port position. Install the connector so that the index mark is visible. 4. Install the indicator (188) on the upper connector (410) using the nut (192). Ensure that the indicator is aligned with the in...

Page 13 - VIII TROUBLESHOOTING; the; Plug Seal Assembly Leaks.; If more information is required contact the factory.; Plug to Bonnet Stem Seal Leaks to Atmosphere.

(I-0320--.doc/13) 13 VIII TROUBLESHOOTING A. Actuator Does Not Align Plug (130) to Port. 1. Check the multiport/actuator connector for looseness. 2. Check the Switchpak/actuator connector for looseness. 3. Check the motor for stalling or overload. 4. Check the speed reducer for visual leakage or noi...

Page 14 - IX DRAWINGS

Page 20 - TYPICAL MULTIPORT SEAL COMPONENTS

(I-0320--.doc/20) 20 X TYPICAL MULTIPORT SEAL COMPONENTS PLUG SEAL COMPONENTS SEAL ASSEMBLY (L–>R: BACKUP PLATE, O-RING, SEAT RING, SEAL INSERT, ASSEMBLY)

Page 32 - C: Pacific Scientific Motors

(I-0320--.doc/appendix) 32 C: Pacific Scientific Motors

Page 39 - B: Boston Gear Gearbox