Emerson HD7998- Manuals

5 Installing The Batteries NOTE : The battery compartment is located inside the CD compartment. 1.) Slide the Open “ ” switch to the right to open the CD door. If you have not already done so, remove the dummy CD ‘transit card’ and discard it. 2.) Press on the locking tab on the battery door in the ...

6 Connecting The Stereo Headphones Connect the plug of the supplied stereo headphones to the green-colored headphone jack on the right side of the cabinet. NOTE : Make sure the headphone plug is inserted into the headphone jack as far as it will go. If the plug is not fully inserted, you may only he...

7 LOCATI ON OF CONTROLS AND INDI CATORS 20 TRACK PROGRAMMABLE CD PLAYER 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 HD7998_B081105.p65 11/8/2005, 15:05 7

9 1.) PGM (Program) Indicator – Appears when programming tracks or playing programmed tracks. 2.) ROCK , SRR , POP Indicators – Appears when repeatedly pressing the EQ button to select the corresponding EQ setting. 3.) VOL Indicator – Appears when pressing the VOLUME + or – buttons to adjust the vol...

10 OPERATI NG I NSTRUCTIONS General Controls H O L D S w i t c h The HOLD switch on the right side of the cabinet must be in the ‘Off’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘On’ (ri...

11 Normal CD Playback • Make sure you have installed the batteries. • Make sure the HOLD switch is set to the ‘Off’ (left) position. • Press the “VOLUME –” button to a low volume setting before you put on the headphones. 1.) Slide the CD door Open “ ” switch to the right to unlock and open the CD do...

12 6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘Off’ automatically to conserve the batteries and the display goes blank. ...

15 Programmed Playback You can program up to 20 tracks on a disc to play in any desired order. Note: You can program a disc either during playback or in Stop mode. 1.) Press the PROG button once. The PGM indicator and the Track n u m b e r “ 0 0 ” w i l l f l a s h a n d t h e Program number “ 01 ” ...

16 Cl ean i ng t he Cabi n et W ipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak solution of neutral detergent and water, and then wipe clean. Cl ean i n g t he Le ns A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not work. Open the...

17 L IM IT ED WAR RA NT Y Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will pro...

5 Installing The Batteries NOTE : The battery compartment is located inside the CD compartment. 1.) Slide the Open “ ” switch to the right to open the CD door. If you have not already done so, remove the dummy CD ‘transit card’ and discard it. 2.) Press on the locking tab on the battery door in the ...

6 Connecting The Stereo Headphones Connect the plug of the supplied stereo headphones to the green-colored headphone jack on the right side of the cabinet. NOTE : Make sure the headphone plug is inserted into the headphone jack as far as it will go. If the plug is not fully inserted, you may only he...

7 LOCATI ON OF CONTROLS AND INDI CATORS 20 TRACK PROGRAMMABLE CD PLAYER 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 HD7998_B081105.p65 11/8/2005, 15:05 7

9 1.) PGM (Program) Indicator – Appears when programming tracks or playing programmed tracks. 2.) ROCK , SRR , POP Indicators – Appears when repeatedly pressing the EQ button to select the corresponding EQ setting. 3.) VOL Indicator – Appears when pressing the VOLUME + or – buttons to adjust the vol...

10 OPERATI NG I NSTRUCTIONS General Controls H O L D S w i t c h The HOLD switch on the right side of the cabinet must be in the ‘Off’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘On’ (ri...

11 Normal CD Playback • Make sure you have installed the batteries. • Make sure the HOLD switch is set to the ‘Off’ (left) position. • Press the “VOLUME –” button to a low volume setting before you put on the headphones. 1.) Slide the CD door Open “ ” switch to the right to unlock and open the CD do...

12 6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘Off’ automatically to conserve the batteries and the display goes blank. ...

15 Programmed Playback You can program up to 20 tracks on a disc to play in any desired order. Note: You can program a disc either during playback or in Stop mode. 1.) Press the PROG button once. The PGM indicator and the Track n u m b e r “ 0 0 ” w i l l f l a s h a n d t h e Program number “ 01 ” ...

16 Cl ean i ng t he Cabi n et W ipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak solution of neutral detergent and water, and then wipe clean. Cl ean i n g t he Le ns A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not work. Open the...

17 L IM IT ED WAR RA NT Y Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship, under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S. With your dated proof of purchase, we will pro...