Emerson ControlWave GFC IStran- Manuals

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) 1.1 Physical Description The IStran assembly measures 6.25 inches (length) by 4.50 inches (width) by approximately 1 inch (depth). (See Figure 1-2, 1-3, and 1-4. ) The IStran assembly consists of the following major components:  O...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Figure 1-4. IStran PCB Mounted on Base Plate (Cover removed) 1.1.1 IStran PCB The IStran PCB provides two interfaces designated hazardous and non-hazardous. You configure each interface independently to operate in either switched o...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Issued Nov-09 Function and Electrical Characteristics 2-1 Chapter 2 – Function and Electrical Characteristics You can use the ControlWave GFC Intrinsically Safe IStran Communication Interface ( IStran ) in both hazardous and non- h...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) 2-2 Function and Electrical Characteristics Issued Nov-09 Position Name Function HPOUT and signals) HJ1-7 HPOUT Hazardous Power HJ1-6 HRX3 Signal Input HJ1-5 HRX2 Signal Input HJ1-4 HRX1 Signal Input HJ1-3 HTX3 Signal Output (Follo...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Figure 2-1. Setting Jumper HJP1 2.1.2 Non-Hazardous Interface Typically you connect the non-hazardous interface to a radio or modem located with the IStran assembly in a non-hazardous or Division 2 rated area. Table 2-4 identifies ...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) 2-4 Function and Electrical Characteristics Issued Nov-09 Table 2-5 provides the characteristics of the non-hazardous interface. Table 2-5. Non-Hazardous Interface Characteristics Description Specification NPIN Voltage (When HPOUT ...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Figure 2-2. Setting Jumper NJP1 2.2 Switched & Unswitched Modes You can configure each IStran interface independently to operate in switched or unswitched mode. In switched mode, the TX drivers can enter a high-impedance state ...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) 2-6 Function and Electrical Characteristics Issued Nov-09 2.2.1 Configuring the Hazardous Interface for Switched Mode To configure the hazardous interface for switched mode, place the supplied shorting jumper in the HJP1 position m...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) When hazardous interface signal input HRX3 is at a high (positive) level, NPOUT turns on and can supply power to an external device. When HRX3 is at a low (or negative) level, NPOUT turns off. You determine the voltage drop between...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Issued Nov-09 System Wiring 3-1 Chapter 3 – System Wiring This chapter includes details on grounding and wiring for the IStran. 3.1 Introduction to System Wiring The IStran connects a radio, modem, or other communications device to...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) 3.3 Cable Length Underwriter’s Laboratories (UL) lists the IStran for use with cable lengths up to 25 feet on either or both interfaces. Typically, you install the IStran in close proximity to the communications device (connected t...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Figure 3-2 is similar to Figure 3-1 except it uses an MDS radio instead of a modem. Figure 3-2. Radio System with Single Power Source Figures 3-3 and 3-4 illustrate an externally powered CW-GFC-IS (without a modem or radio). In thi...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Chapter 4 – Installation 4.1 Installation Overview The IStran and the communications device reside in a non-hazardous or Division 2 rated area, while the CW-GFC-IS resides in a Division 1, Division 2, or non-hazardous area. You mus...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) 4-2 Installation Issued Nov-09 IStran. Do not install any other wiring through the same hole or allow other wires to share a cable or conduit with the intrinsically safe wiring. Secure the intrinsically safe wiring and limit slack ...

ControlWave GFC IS Communication Interface Manual (CI-CW-GFC-ISTRAN) Issued Nov-09 Specifications 5-1 Chapter 5 – Specifications 5.1 Environment The IStran design supports operation inside a building or a weather-proof enclosure only. 5.2 Operating Specifications Table 5-1 provides the operating spe...

Remote Automation Solutions Repair Authorization Form ( Providing this information will permit Remote Automation Solutions to effectively and efficiently process your return. Completion is required to receive optimal lead time. Lack of information may result in increased lead times.) Form GBU 13.01 ...

ControlWave GFC-IStran Instruction Manual Issued Nov-09 Index I-1 Index F Field wiring diagrams .......................................... 3-2 Figures 1-1. Istran Front View ..................................... 1-1 1-2. Physical Dimensions - Istran Front View 1-2 1-3. Physical Dimensions – IStran E...

Customer Instruction Manual CI-CW-GFC-ISTRAN November, 2009 ControlWave GFC IStran Emerson Process Management Remote Automation Solutions 1100 Buckingham Street Watertown, CT 06795 Phone: +1 (860) 945-2262 Fax: +1 (860) 945-2525 www.EmersonProcess.com/Remote Emerson Process Management Remote Automat...