Emerson CF980MAB 00 - Manuals

Page 2 - WARNING; THIS FAN IS SUITABLE FOR DAMP LOCATIONS SUCH AS

2 WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to pre...

Page 3 - Unpacking Instructions; Installed Wire Length; This Manual Is Designed to Make it as Easy as Possible for You to

Tools Needed for Assembly One Phillips head screwdriverOne stepladder MATERIALS Wiring, outlet box and box connectors must be of typerequired by the local code. The minimum wire wouldbe a 3-conductor (2-wire with ground) of the followingsizes: Unpacking Instructions For your convenience, check-off b...

Page 4 - Electrical Requirements; Ceiling Fan Procedures; General; Figure 2; Figure 1

4 Electrical Requirements Your new ceiling fan will require a grounded electricalsupply line of 120 volts AC, 60 Hz, 15 amp circuit.T h e o u t l e t b o x m u s t b e s e c u r e l y a n c h o r e d a n dcapable of withstanding a load of at least 50 pounds. To reduce the risk of fire, electric shoc...

Page 5 - Figure 7

5 CAUTION: Before installing and tightening thes c r e w s , b e s u r e t h e r e a r e n o w i r e s p i n c h e dbetween the bottom of the light kit assembly andfan motor. 5. Install the three #10-24 x 5/16” pan head screws tosecure the light kit assembly to the lower housing(Figure 4). #10-24 x ...

Page 7 - Carefully lift the fan and seat the hanger ball/down-; SUPPLY WIRES AND; How to Hang Your Ceiling Fan

7 2. Carefully lift the fan and seat the hanger ball/down- rod assembly on the hanger bracket that was justattached to the outlet box (Figure 13). Be sure thegroove in the ball is lined up with the tab on thehanger bracket (Figure 12). Failure to seat tab in groove could cause damage toelectrical wi...

Page 8 - DO NOT USE; How to Wire Your Ceiling Fan

8 OUTLET BOX BLACK SUPPLY WIRE BLACK/WHITE RECEIVER WIRE BLACK FAN WIRE BLUE FAN WIRE BLUE RECEIVER WIRE YELLOW RECEIVER WIRE DO NOT USE CEILING COVER WHITE RECEIVER WIRE WHITE FAN WIRE WIRE CONNECTOR RECEIVER WHITE SUPPLYWIRE SUPPLY GROUNDWIRE (GREEN OR BARE) HANGER BALLGROUND WIRE(GREEN) HANGER BR...

Page 10 - Halogen Bulb and Glass Installation

2. Place the glass onto the light kit assembly aligningthe three flat areas on the top flange of the glasswith the three pins on the inside of the assembly(Figure 19). Then turn the glass clockwise until itstops turning. 3. Your ceiling fan is now installed and wire to becontrolled by your remote co...

Page 11 - Installation

11 Setting Operating Frequency of Wall Control and Receiver (Figure 20) Your wall control and receiver have code switcheswhich must be set in one of 16 possible code combi-nations. The four levers (numbered 1, 2, 3, and 4) onthe switches are factory-set in the ON (up) position.Change the switch sett...

Page 12 - Trouble Shooting; Fan/Light Fails to Operate; Operating Your Ceiling Fan; IMPORTANT; To turn your fan off, press the FAN OFF button.; Maintenance; IMPORTANT CARE INSTRUCTIONS; Accessories

12 AIRFLOWDIRECTIONBUTTON LIGHTBUTTON FANSPEEDBUTTONS FAN OFFBUTTON REDINDICATORLIGHT FAN OFF LOW MED HI LIGHT REV Figure 23 Trouble Shooting Wall Control Fan/Light Fails to Operate • Check that the wall switch for the ceiling fan is in the “ON” position. • Check that the battery is good (red indica...

Page 13 - INSTRUCTION TO THE USER; • Reorient or relocate the receiving antenna.

13 INSTRUCTION TO THE USER (if device contains a digital device) This equipment has been tested and found to comply with the limits for a class B digital device, pursuant topart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-ence in a residen...

Page 14 - FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER

Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. 2. Loose power line connections to the fan, or loose 2. Check line power connections to fan and switch wire switch wire connec...

Page 15 - Repair Par ts

15 Repair Par ts 9 HI HI MED MED LOW LOW FAN OFF REV REV LIGHT 1 5 67 3 2 10 4 8 11 16 17 19 18 23 14 20 21 12 13 15 24 22

Page 16 - Air Comfort Products; DIVISION OF EMERSON ELECTRIC CO.; Repair Par ts Listing; Part Numbers

Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Part No. F40BP73530000 Printed in China 10/07 Form No. BP7353 Repair Par ts Listing Part Numbers Key Model No. Model No. No. Description CF980MBX 00 CF980MAB 00 * Hanger Pack, Consisting of: 761655-67 7616...