Emerson CF725GBZ00- Manuals

Page 3 - Tools Needed for Assembly; Installed Wire Length; WARNING; a. Fan motor and upper housing

3 This Manual is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Do not install or use fan if any part isdamaged or missing. Call Toll-Free: 1-800-654-3545 ! WARNING This product is designed to use onlythose parts supplied with this product...

Page 4 - Remove the fan motor and upper; Electrical Requirements

1. Two 1-1/4” threaded studs2. Two knurled knobs3. Two lockwashers4. Three wire connectors5. One clevis pin6. One hairpin clip7. Eleven M5 x 18mm oval head screws 8. Sixteen M5 x 6mm slotted Phillips washer head screws 4 m. One loose parts bag containing: NOTE: Place the parts from the looseparts ba...

Page 5 - General; Ceiling Fan Procedures; Mount the fan blades to the blade; How to Assemble Your; Rotate the motor and upper housing; Figure 1

5 General Your Emerson ceiling fan comes suppliedwith a SW102 Fan/Light Wall Control anda Remote Control Receiver. This systemallows you to regulate your ceiling fanspeed and light intensity. NOTE: An optional Emerson ElectricSR100 Remote Control may also beused to control your ceiling fan. Ceiling ...

Page 6 - Remove the hanger ball by loosening; Figure 3; Figure 4; Carefully position a M5 x 18mm oval

6 4. Remove the hanger ball by loosening the setscrew in the hanger ball until theball falls freely down the downrod(Figure 3). Remove the pin from thedownrod, then remove the hanger ball.Retain the pin and hanger ball forreinstallation in step 10. PIN HANGERBALL SETSCREW DOWNROD Figure 3 HAIRPIN CL...

Page 7 - Figure 5; Place the ceiling canopy over the; How to Hang; Figure 7; You have now completed the initial; Figure 6

7 REINSTALL THREE M4 x 15mm PAN HEAD SCREWS AND RUBBER WASHERS UPPER HOUSING RING MOTOR AND UPPER HOUSING ASSEMBLY Figure 5 9. Make sure the grommet is properlyinstalled in the coupler cover, thenslide the coupler cover on the downroduntil it rests on the motor and upperhousing assembly (Figure 6). ...

Page 8 - Carefully lift the fan and seat the hanger; Figure 8; Figure 9; How to Wire

8 To reduce the risk of fire, electricshock, or personal injury, mount fanto outlet box marked “Acceptable forFan Support”, and use screwssupplied with outlet box. Most outletboxes commonly used for support oflight fixtures are not acceptable forfan support and may need to bereplaced. Consult a qual...

Page 9 - c. Securely connect the supply black wire

9 1. Position the supply wires to the left side of the outlet box (Figure 10); positionthe fan wires to the right side. Partiallyinsert the remote control receiver (flatside up) until one end rests on thehanger ball as shown in Figure 10. NOTE: Make all wiring connectionsusing wire connectors (suppl...

Page 10 - Push the wires and connectors up into; Engage the connectors of the housing

To avoid possible fire or shock, makesure that the electrical wires arecompletely inside the outlet box andnot pinched between the ceilingcanopy and the ceiling. ! WARNING SW102 FAN/LIGHT WALL CONTROL (SUPPLIED) BLACK BLACK WHITE RED BLACK WHITE HANGER BALL GREEN WIRE (GROUND) FROM HANGER BALL AND H...

Page 11 - Position the housing downlight; Operating Your; IMPORTANT

10. Screw in two 60-watt (maximum) candelabra bulbs (supplied) in thelight fitter sockets (Figure 14). 11. Remove the finial nut, hex nut and washer from housing downlightassembly. 12. Position the glass over the threaded nipple. Slide the washer onto thethreaded nipple and gently tighten thehex nut...

Page 12 - IMPORTANT CARE INSTRUCTIONS; Accessories

Do not use water when cleaning yourceiling fan. It could damage themotor or the blades and create thepossibility of an electrical shock. ! WARNING The use of any other control notspecifically approved for this fancould result in fire, shock andpersonal injury. ! WARNING This product is designed to u...

Page 13 - FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX

Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. WARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan. to fa...

Page 14 - Repair Parts; HOW TO ORDER REPAIR PARTS

Repair Parts 9 3 2 1 5 4 12 19 16 8 10 20 11 13 6 7 17 14 16 22 15 18 21 23 FAN OFF LOW MED HI LIGHT Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REPAIR PARTS WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFORMATION: • PART NUMBER• NAME OF ITEM•...

Page 15 - Repair Parts Listing

Part Numbers Key Model No. Model No. No. Description CF725GBZ00 CF725GES00 * Hanger Pack, Consisting of: 761655-75 761655-76 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod — — * Parts Bag, Containing: 763737 763737 4 Wire Connector (3) — — 5 Threaded Stud, 1-1/4” (2) — — 6 Knurled Knob, 8-32 (2) —...

Page 16 - LIMITED WARRANTY; A i r C o m f o r t P r o d u c t s; DIVISION OF EMERSON ELECTRIC CO.

LIMITED WARRANTY What The Warranty Covers:This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects inworkmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is:As it...