ECHO PAS-2601 TYPE 1E - Manuals

2 CopyRight© 2011 By Echo, Incorporated All Rights Reserved. I ntroductIon Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job dependability. Read and understand this manual included with your attach- ment. You will find this manual easy to...

Page 3 - CAUTiOn; CIRCLE AND SLASh SYMBOL; This symbol means the specific action; DAngEr

PAS 80 T ooTh B lAde T rimmer A TTAchmenT o PerATor ' S m AnuAl 3 s afety manual safety symbols and Important InformatIon Throughout this manual and on the product itself, you will find safety alerts and helpful, informational messages pre - ceded by symbols or key words. The following is an explana...

Page 4 - wArning; personal

4 Physical Condition Your judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye Protection Wear eye protection that meets ANSI Z87.1 or CE re- q...

Page 6 - equIpment; combined with a non approved ECHO product.; securely; in place. Replace if shield is damaged or missing.; IMPORTANT; 0-Tooth blade requires professional sharpening.; escrIptIon; instructions for specific information.; ALWAYS; before removing obstructions, clearing debris, or servicing unit.; DO NOT

6 equIpment wArning Use this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined with a non approved ECHO product. Before operation a complete check of the unit must be performed; • Check unit for loose/missing nuts, bolts and screws. Tighten...

Page 7 - ontents; parts. Use the contents list to check for missing parts.; Brushcutter Attachment; LOWER DRIVE ShAFT ASSEMBLY; Drive Cable, Metal Blade and Safety Decals.; FLEXIBLE DRIVE CABLE -; with ECHO; METAL BLADE ShIELD; Shaft Decals

PAS 80 T ooTh B lAde T rimmer A TTAchmenT o PerATor ' S m AnuAl 7 c ontents After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts. ___ 1 - Pro Attachment Series TM Brushcutter Attachme...

Page 8 - NOTE

8 a ssembly wArning Do not perform maintenance or assembly procedures with engine running. Parts Required: Power Head Shaft, Attachment Lower Shaft Assembly, Metal Shield, Bracket, Barrier Bar D A A B D B power head shaft / attachment lower shaft assembly 1. Set Power Head/Shaft Assembly on a level ...

Page 9 - -screw front handles

PAS 80 T ooTh B lAde T rimmer A TTAchmenT o PerATor ' S m AnuAl 9 Install Metal Shield 1. Loosely attach bracket (A) to shield (B) and attach to bottom of gear housing (C) with screws and nuts provided. Tighten all attaching hardware. blade InstallatIon Install Blade 2. Install upper plate (D) on sp...

Page 10 - aIntenance

10 balance unIt 1. Put on harness and attach unit to harness. 2. Slide harness clamp up and down until unit balances with head ap- proximately 2 - 3 in. from the ground. 3. Tighten clamp screw. NOTE In case of Emergency, the trimmer/brushcutter can be released from the the harness by pulling up on t...

Page 11 - = Moderate difficulty. Some specialized tools may be required.; Component; maIntenance; Level; Gear Housing; Install flex cable. Make sure cable end engages upper drive shaft

PAS 80 T ooTh B lAde T rimmer A TTAchmenT o PerATor ' S m AnuAl 11 skIll levels Level 1 = Easy to do. Common tools may be required. Level 2 = Moderate difficulty. Some specialized tools may be required. A Component Maintenance Procedure Skill Level Interval Drive Shaft Grease 1 Every 25 hours of use...

Page 12 - PAS 80 Tooth Blade Attachment; torage; Storage Hook Installation; Insert small end of hook into locating hole on attachment shaft.; pecIfIcatIons

12 Shaft Length ------------------------------------------------ 870 mm (34.3 in.)Attachment Width ----------------------------------------- 280 mm (11 in.)Attchment Height ------------------------------------------ 255 mm (10 in.)Weight (dry) w/blade -------------------------------------- 1.5 kg. (...

Page 13 - notes

PAS 80 T ooTh B lAde T rimmer A TTAchmenT o PerATor ' S m AnuAl 13 notes

Page 16 - Call; always; Number and Serial Number of the unit with you. You can find these; COnSUMEr PrODUCT; Replacement Operator, Safety Manuals, and Parts Catalogs

ECHO, inCOrPOrATED 400 O akwOOd R Oad L ake Z uRich , iL 60047 www.echo-usa.com DEALEr? Call 1-800-432-ECHO or www.echo-usa.com s ervIcIng I nformatIon parts / serIal number Genuine ECHO Parts and ECHO REPOWER™ Parts and Assem- blies for your ECHO products are available only from an Authorized ECHO ...