Earthquake Sound P12 - Manuals

Page 2 - Safety Instructions

Safety Instructions 13. Damage Requiring Service — The Component 1. Read Instructions — All the safety and operation should be served only by EQ qualified serviced instructions should be read before the Earthquake personnel when: Component is operated. a. The power-supply cord or the plug has been 2...

Page 3 - Contents; Earthquake • MiniMe User Manual

WARNING: The MiniMe subwoofers are capable of generating high sound pressure levels. You should exercise caution when operating these speakers. Long term exposures to high levels of sound pressure will cause permanent damage to your hearing. Sound pressure levels exceeding 85dB can be dangerous with...

Page 5 - Control Panel Overview; DIGITAL

(1) Line Level RCA Inputs terminals will accept up to 16-gauge quality speaker Connect with RCA type patch cords to the line level wire. The Inputs should be connected to the left and output of your receiver or pre-amp. If your pre- right speaker terminals of your amplifier or receiver. amplifier or...

Page 6 - Control Panel Overview Continued

(6) Auto ON/OFF (10) Sub Operation Switch When the main “POWER” ON/OFF switch is in the In LFE position, the Frequency adjustment becomes “OFF” position, this switch has no affect on the disabled and the subwoofer runs in a Full range subwoofer. When the main “POWER ON/OFF” switch mode, from 20Hz - ...

Page 9 - Location

MiniMe 1 P= Passive Radiator A= Active Driver MiniMe 2 P A MiniMe 3 P A Location F a c t : S u b w o o f e r s r e p r o d u c e f r e q u e n c i e s w i t h #1 is very good positioning. wavelengths that are long in relation to the dimensions of most living rooms. Standing waves will boost or #2 is...

Page 10 - System Configurations; MAIN

System Configurations The following pages show some typical connections that you might make in your installation. They show how the inputs and outputs of the Earthquake sub are connected to your pre-amplifier or receiver. Connections to a pre-amplifier's subwoofer output If your pre-amplifier has a ...

Page 12 - Using the line speaker-level inputs

Earthquake Sound, 2727 McCone Avenue, Hayward, CA 94545 USA www.earthquakesound.com VOLUME FREQUENCY MODE PHASE AUTO MIN 50Hz MAX RIGHT POWER LEFT 160Hz SUB 0 OFF LFE 180 ON 110-120VAC~60Hz220-240VAX~50Hz FUSE: 115V, T6.4AL/250VFUSE: 230V, T3.2AL/250V ON 110-120V 220-240V OFF TO REDUCE RISK OF FIRE ...

Page 13 - Adjusting the controls; Method One: Typical: Listening and making; Control settings

AUTO OFF ON VOLUME FREQUENCY MODE PHASE MIN 50Hz MAX 160Hz SUB 0 LFE 180 Adjusting the controls There are two main methods for adjusting the level, crossover frequency and phase of the Earthquake MiniMe to match a system. ? Method One: Typical: Listening and making adjustments to suit your taste. ? ...

Page 15 - Limited 5-Year Warranty; Burnt tracers on PCB.

Limited 5-Year Warranty Earthquake warrants the original purchaser that all Factory Sealed New Audio Products to be free from defects in material and workmanship under normal and proper use for a period of five (5) years from the date of purchase (as shown on the original bill of sale with serial nu...

Page 16 - Earthquake Sound Corporation

Earthquake Sound Corporation 2727 Mc Cone Avenue, Hayward, California 94545 Ph (510) 732-1000 Fax (510) 732-1095 www.earthquakesound.com