Earthquake Sound Cinenova 5 - Manuals

Page 2 - Introduction; Table Of Contents; Warranty Information; Product Registration; Cinénova Grande

2 Introduction Table Of Contents Earthquake Sound Customer Support [email protected] Tel: 800-576-7944 Fax: 510-732-1095 Earthquake Sound Corporation 2727 McCone Avenue Hayward, CA 94545 Tel: 510-732-1000 Fax: 510-732-1095 © 2010 Earthquake Sound Corporation. All rights reserved. This documen...

Page 4 - About Cinénova Amplifiers; Your Cinénova Grande; Important Safety Instructions; Safety First; Your Cinénova 7

About Cinénova Amplifiers 4 Your Cinénova Grande Earthquake Sound Thank you for purchasing this Cinénova Grande reference amplifier designed to “Sounding good” and “looking good” are both integral characteristics of a satisfy your audiophile needs for music enjoyment. The Cinénova Grande is Cinénova...

Page 6 - Pre-setup with Cinénova Grande; Getting Started with the Cinénova Grande; Handles; Cinénova Grande Front Panel Overview; Cinénova Grande Front Panel; Cinénova

Pre-setup with Cinénova Grande 6 Earthquake Sound 7 Confirm the voltage setting of the amplifier. It must match the voltage in your home. The amp is set by factory to either 120V or 240V. Check above the circuit breaker for this information. Getting Started with the Cinénova Grande 5) PLUG IN POWER ...

Page 8 - Rear Panel of Cinénova Grande; Cinénova Grande Panel Overview; Technology and Materials

8 2. RCA Input: Accepts low-level signal from any source. It takes 1.6V to output the rated power. Rear Panel of Cinénova Grande Cinénova Grande Panel Overview 9 Earthquake Sound EZXS Detachable Monaural Blocks: Five or seven totally independent mono-block amplifiers each with its own power supply c...

Page 10 - Cinénova Grande 5 or 7 Filter Settings; Adjusting The Filters; Pre-setup with Cinénova 7; Getting Started with the Cinénova 7

11 10 Each channel - monaural block - of the Cinénova Grande amplifiers comes equipped with a fully buffered variable filter (range: 20 Hz to 5000 Hz). Once a crossover point is selected, the block can be run in low pass or high pass configuration, simply by a flick of a 3-way switch; the filter can...

Page 12 - Cinénova 7 Front Panel Overview; Cinénova 7 Front Panel; Cinénova 7 Panel Overview; Rear Panel of Cinénova 7; Output Binding Posts:

13 RF MAX GND +12V AC110V/60Hz MIN SPEAKER OUTPUT INPUT SELECTOR RCA XLR USE ONLY WITH A 250V FUSE 12 Cinénova 7 Front Panel Overview Cinénova 7 Front Panel Cinénova 7 Power Amplifiers 1. Master Power Switch: Turns the current to the amplifier ON or OFF manually. When turning on the amplifier via a ...

Page 14 - Troubleshooting Cinénova Grande 5 or 7; Troubleshooting All Cinénova Models; Trouble Shooting and Maintenance

14 Troubleshooting Cinénova Grande 5 or 7 Amplifier “ON” No Sound a) Completely shut your system down including your Cinénova via the circuit breaker. b) Now turn on the Cinénova only. Check to see if the front Main Power Switch is on. c) Check the Input Selector switch and make sure that it is in t...

Page 16 - Sound That Will

Sound That Will Move You. Earthquake Sound reserves the right to amend details of the specifications without notice. © Copyright Earthquake Sound Corporation Earthquake Sound Corporation 2727 McCone Avenue, Hayward CA, 94545 Phone: (510) 732-1000 U.S. Toll Free: (800) 579-7944 Fax: (510) 732-1095