Dyson AM10WS - Manuals

AUTO Controlling the humidity manually Increase target humidity. 30 to 70% Decrease target humidity. 70 to 30% The appliance will not mist unless the target humidity setting is above the current room humidity level. Automatic mode Comfortable humidity is automatically selected by the appliance. Airf...

Some cleaning chemicals are harmful to the appliance and should not be used. Use of these will invalidate your guarantee. Do not use: Alcohol and strong acid mixes, solvent (acetone) and oil based products, alkali bleach mixes, air fresheners, aroma oils, scented oils, hot water, brushes, abrasive m...

Wipe over air loop amplifier, paying close attention to the air gaps. Wipe with a lint-free microfibre cloth. Turn the appliance into standby mode/‘OFF’. Unplug from the mains electricity supply. 1 3 2 Empty the trough and wipe over all surfaces. Small spillages may occur. Do not rinse under the tap...

Unclip the loop amplifier surround: pull from the lower edge by hand, gently but firmly. Turn the appliance into standby mode/‘OFF’. Unplug from the mains electricity supply. 1 Once a month (and before/after storage) Empty the water tank. To release the water chimney, twist the dial a quarter of a t...

What do the lights mean? Tilted The base is not level. Water treatment The AM10 is treating the water. This takes 3 minutes. When the animation stops, the AM10 will start to humidify. Tank is empty Switch ‘OFF’ and refill. Please call the helpline. Please call the helpline. AM10 is too cold. Increas...

Using your humidifier Please read the ‘Important Safety Instructions’ in this Dyson Operating Manual before proceeding. Introduction • This is a cool mist, ultrasonic type of humidifier. Moist air is directed into the room from the loop amplifier. • Water passes over a UV-C emitter to ensure that it...