Page 2 - IMPORTANT SAFEGUARDS
Code Rev. D 20140818 (IEC) 2 Please read this manual carefully before installing and starting up, and store it in a safe place. If you pass on the product to another person, hand over this instruction manual along with it. IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions sh...
Page 3 - SAVE THESE INSTRUCTIONS; DISPOSAL
Code Rev. D 20140818 (IEC) 3 hazardous for anyone other than an Authorised Service Person to carry out servicing or repairs to this appliance. In Queensland of Australia the authorized person must hold a Gas W ork Authorisation for hydrocarbon refrigerants, before carrying out servicing or repairs w...
Page 4 - THIS APPLIANCE MUST BE EARTHED.; NON-REWIREABLE MAINS PLUG
Code Rev. D 20140818 (IEC) 4 The symbol on the product or its packaging indicates that this product is not to be handled as normal household waste but is to be taken to a recycling collection point for electrical and electronic goods. By correctly disposing of this product you are contributing to ...
Page 7 - BUILT-IN CABINETRY INSTRUCTIONS
Code Rev. D 20140818 (IEC) 7 A (mm) B (mm) C (mm) 37.5cm Wide 375 380 495 60cm Wide 595 610 520 FULLY INTERGRATED BUILT-IN-COLUMN INSTRUCTIONS The unit door seals the installed unit almost completely, so an air vent must be provided in the base of the housing. W armed air must be conducted via the v...
Page 8 - ELECTRICAL CONNECTION
Code Rev. D 20140818 (IEC) 8 A (mm) B (mm) C (mm) D (mm) 100 1480 550 1476 570 125 1772 550 1768 570 170 1772 660 1768 680 ELECTRICAL CONNECTION WARNING: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by a qualified electr...
Page 10 - OPERATING YOUR
Code Rev. D 20140818 (IEC) 10 cabinet. (Fig. 4) 5. Unscrew and transfer door supporter ○ ,10 to the opposite side. At the same time remove the stopper pin ○ ,7 of bottom hinge to the opposite designated position or unscrew and transfer the hinge pin ○ ,7a of bottom hinge to the opposite designated p...
Page 13 - TEMPERATURE ALARM
Code Rev. D 20140818 (IEC) 13 The Controls of Your Unit Upper Control Unit Lower Control Unit POWER To turn the appliance on/off, press and hold the key for 5 seconds until themperature display lights up or goes out. NOTE: Pressing the key once can switch off the audible alarm when the alarm is on. ...
Page 14 - DOOR ALARM; INTERIOR LIGHT; SABBATH MODE
Code Rev. D 20140818 (IEC) 14 The temperature the appliance is set at determines the temperature the appliance recognises as being too warm or too cool. The alarm will sound and the temperature display will flash: - When you switch the appliance on, if the temperature inside the appliance is very di...
Page 15 - ECO DEMO MODE
Code Rev. D 20140818 (IEC) 15 Sabbath mode is available for the observance of certain religious holidays. This mode turns off the displays, interior light and audible alarms and prevents them from turning on again. Normal cooling operations will still take place. To initiate Sabbath mode, press the ...
Page 16 - CARE AND MAINTENANCE; REMOVING SHELVES
Code Rev. D 20140818 (IEC) 16 Red Pinot Noir 16 61 Red Grenache, Syrah 16 61 Red Vintage Pinot Noir 18 65 Cabernet & Merlot: French, Australian, New Zealand, Chilean, Italian, Spanish, Californian, Argentinean… 20 68 Vintage Bordeaux … Room temperature not exceeding 20ºC/68ºF IMPORTANT INFORMATI...
Page 17 - POWER FAILURE; VACATION TIME; ENERGY SAVING TIPS
Code Rev. D 20140818 (IEC) 17 DOOR LOCK If the unit is provided with a lock system, the keys are located inside the plastic bag that contains the Owner’s Manual. Insert the key into the lock, push in and turn it counterclockwise to unlock the door. To lock the door do the reverse operation making su...
Page 18 - PROBLEMS WITH YOUR APPLIANCE; TROUBLESHOOTING GUIDE
Code Rev. D 20140818 (IEC) 18 PROBLEMS WITH YOUR APPLIANCE You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling customer service. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE REMEDY App...
Page 19 - WARRANTY; A copy of the receipt with purchasing date.
Code Rev. D 20140818 (IEC) 19 The door is not closed completely. The door gasket does not seal properly. Close door properly. Check the door seal and clean or replace. The light does not work. Appliance is not connected to a power supply. The circuit breaker tripped or a blown fuse. Th...