Dukane DK100 - Manuals

03-TM-0037 REV 13 Page 9 of 24 2.6. INSTALLATION PROCEDURES FORTHE DK100/DK120 AND THE N30A26SERIES MOUNTING KIT. 2.6.1. GENERAL. Model N30A26 SeriesMounting Kit (Cradle Type) is an aluminumextrusion with a screw-attached securing platethat provides rugged mounting and protection ofthe beacon within...

03-TM-0037 REV 13 Page 11 of 24 If vertical mounting is employed, the switch endshould be facing downwards to reduce theaccumulation of dirt, grease, and water on theswitch end. Rotate the beacon in the mount, sothat the markings and beacon replacement datelabel can be read. Figure 6. N30A21A Mounti...

03-TM-0037 REV 13 Page 12 of 24 2.8. INSTALLATION PROCEDURES FORTHE DK130/DK140 AND THE N30A29SERIES MOUNTING KIT. 2.8.1. GENERAL. Model N30A29 SeriesMounting Kit (Cradle Type) is an aluminumextrusion with a screw-attached securing platethat provides rugged mounting and protection ofthe beacon withi...

03-TM-0037 REV 13 Page 16 of 24 SECTION IV TESTING 4.1. GENERAL. The DK Series beacon should be tested beforeand after installation in the mounting kit and atrecommended maintenance intervals. See Sec-tions V and VI. 4.2. BATTERY TESTING. Use a high impedance voltmeter (input imped-ance of 10 M ohms...

03-TM-0037 REV 13 Page 17 of 24 SECTION V MAINTENANCE DK100/DK130 5.1. GENERAL. This section contains DK100/DK130 Beaconcleaning, beacon testing, battery testing, disposaland storage procedures. Initially beacons must betested at every installation or beacon change. Therequired schedule for battery ...

03-TM-0037 REV 13 Page 18 of 24 NOTE Replacement of the battery in the DK120or DK140 beacon must be done by aqualified technician. CAUTION TO AVOID INTERNAL DAMAGE, DON O T C L A M P T H E B E A C O N I N AVISE, UNLESS A VISE-CLAMP (P/N810-546) IS USED. SECTION VI MAINTENANCE DK120/DK140 6.1. GENERA...

03-TM-0037 REV 13 Page 19 of 24 Figure 18. Battery End Cover Re- moval With Vise Clamp and Span- ner Wrench 6.6.2. BATTERY REPLACEMENT. A. Both the Vise Clamp (P/N 810-546) and theSpanner Wrench (P/N 810-325) are available inkit P/N 810-2007/KVS. B. Secure the beacon with Vise-Clamp (P/N810-546) as ...

03-TM-0037 REV 13 Page 20 of 24 Figure 20. Beacon Exploded View Showing Relative Location of Battery and Related Parts WARNING REPLACE BATTERY WITH AUTHO-RIZED REPLACEMENT PARTSONLY. USE OF AN UNAUTHO-RIZED BATTERY WILL VOID THEWARRANTY AND MAY CAUSE ANINOPERATIVE OR DANGEROUSCONDITION. USE OF AN UN...

03-TM-0037 REV 13 Page 21 of 24 WARNING DO NOT RECHARGE, DISAS-SEMBLE, HEAT ABOVE 160°F (71°C)OR INCINERATE. THERE IS A RISKOF BATTERY FIRE, EXPLOSION,AND BURNS. 6.8. BATTERY DISPOSAL. Dispose of battery in accordance with all local,state and federal regulations. Dispose of batteriespromptly, keep a...

03-TM-0037 REV 13 Page 22 of 24 SECTION VII WARRANTY DK100/DK120/DK130/DK140 The Dukane Corporation warrants that the electronics and case of the Model DK100/DK120DK130/DK140 Underwater Acoustic Beacon (hereafter referred to as the “unit”) will be free from defects inmaterials and workmanship for si...

03-TM-0037 REV 13 Page 23 of 24 SECTION VIII SERVICE PROGRAM DK100/DK120/DK130/DK140 8.1. BEACON RETURN – DEFECTIVE. 8.1.1. In the case of a failure which is determinedto be within the Warranty terms (Section VII),the beacon will be replaced by Dukane Corpora-tion at the sole discretion of Dukane Co...