Page 2 - TABLE OF CONTENTS; KNOW YOUR GRASS BAGGER; WARNING
TABLE OF CONTENTS CONGRATULATIONS on your purchase of a new Grass Bagger. It has been designed, engineered and manufactured to give you the best possible depend- ability and performance.Should you experience any problem you cannot easily remedy, please contact your nearest authorized ser- vice cente...
Page 3 - SAFETY RULES; SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS; DO NOT
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS DANGER ! THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. GENERAL OPERATION • Read, understand and follow all in...
Page 4 - back up the slope or if you feel uneasy on it, do not; DO; • Do not; CAUTION; In order to prevent accidental starting
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS II. SLOPE OPERATION Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not ...
Page 5 - Battery posts, terminals and related; damage, and deterioration, which could expose
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS • Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting. • Never make adjustments or repairs with the engine running. WARNING Battery posts, terminals and related accessories contain lead and lead comp...
Page 6 - ASSEMBLY; when you are seated on the mower in the op-; UNPACKING INSTRUCTIONS; • Remove all parts and packing materials from both; CARTON 1 CONTENTS; - High Lift Blades; CARTON 2 CONTENTS; - Soft Bag Containers; PARTS IDENTIFICATION; BEFORE ASSEMBLING GRASS BAGGER TO MOWER:
7 ASSEMBLY NOTE: When right hand (RH) and left hand (LH) are mentioned in this manual, it means when you are seated on the mower in the op- erator’s position. UNPACKING INSTRUCTIONS • Remove all parts and packing materials from both cartons. • Check carton contents against list. Be sure all parts ar...
Page 7 - For the collection system to operate properly you will; CHANGING BLADES; Blades are sharp. Protect your hands
8 ASSEMBLY For the collection system to operate properly you will need to replace the cutting blades on your unit with the high lift blades in the kit. 1. Remove mower deck from machine. Refer to Operator’s Manual, if necessary. 2. Remove standard mower blades from deck and install high lift blades ...
Page 8 - MOUNTING COVER ASSEMBLY TO; Depending on model, rear guard hole; For ease of assembly, you may wish assistance from; INSTALLING SPACER PLUG
9 ASSEMBLY 4 MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY 3 BAGGER SUPPORT ASSEMBLY Using hardware provided in kit, attach support 1. mount to unit. Attach hanger bracket to support mount. Do not 2. fully tighten nuts at this time.Secure rear end of support straps to outside of 3. Hanger Bracket hang...
Page 9 - UPPER CHUTE; Attached flex tube to blower and secure with the; which could develop into a fire.
10 ASSEMBLY 6 UPPER CHUTE 1. Attached flex tube to blower and secure with the hose clamp. 2. Slide opposite flex hose end into upper chute.3. Push upper chute through the gasketed opening in the cover assembly. 4. Rotate flex tube and upper chute so that the chute opening is downward toward the cont...
Page 10 - OPERATION; GENERAL RECOMMENDATIONS; For best results mower blades must be kept sharp.; STORAGE; used, you are picking up thatch and debris that has
OPERATION GENERAL RECOMMENDATIONS Always observe safety rules when performing any maintenance. • Before each use check for loose fasteners.• Clean unit thoroughly after each use. BLADE CARE For best results mower blades must be kept sharp. Replace bent or damaged blades. • See BLADE CARE instruction...
Page 11 - PARTS
PARTS 1 3 7 4 5 8 18 11 14 15 16 10 17 12 6 2 20 5 20 19 9 13 20
Page 12 - DESCRIPTION
PARTS ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTION NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED. 539 111139 1.. ....1 .... COVER ASSM, COMPLETE INCLUDES ITEMS 2-4 532 127533 2.. ....1 .... SCREEN, COVER 532 155042 3.. ....1 .... STRIP, REINFORCEMENT 532 130895 4.. .......
Page 14 - SAE
PARTS ITEM PART NO. QTY. DESCRIPTION ITEM PART NO. QTY. DESCRIPTION 522 854602 1.. ....1 .... MOUNT, BAGGER 539 100472 2.. ....4 .... RHSNB-18 x 1¼ 523 112802 3.. ....2 .... PLATE, REINFORCEMENT 522 854702 4.. ....1 .... BRACKET, HANGER 539 990717 5.. ..12 .... NUT 5 / 16 -18 HEX NYLOC 539 115938 6....