Page 3 - SAFETY INSTRUCTIONS FOR POWER TOOLS
1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicate...
Page 4 - GENERAL POWER TOOL SAFETY WARNINGS; SAVE ALL WARNINGS AND INSTRUCTIONS FOR
2 WARNING: To reduce the risk of injury, read the instruction manual. GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings and all instructions Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term “power tool” in the warni...
Page 6 - SAVE THESE INSTRUCTIONS FOR FUTURE USE; Do not operate this tool for long periods of time.
4 WARNING: Always wear proper personal hearing protection that conforms to AS/NZS1270 during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss. • The label on your tool may include the following symbols. The symbols and their definitions are as fo...
Page 7 - INTENDED USE; ASSEMBLY AND ADJUSTMENTS; installing attachments or accessories.
5 FIG. 1 A J B C K I D E F H G INTENDED USE Your jigsaw DW331-XE has been designed for professional cutting of wood, steel, aluminium, plastic and ceramic material. ASSEMBLY AND ADJUSTMENTS WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source be...
Page 9 - When appropriate, connect a dust extraction system designed in; INSTRUCTIONS FOR USE; fasteners that may damage the blade.
7 TO MOUNT THE INSERT INTO THE SHOE 1. Slide the edges (N) into the grooves (O) of the shoe (I).2. Slide the inser t back into position against the shoe. TO MOUNT THE INSERT INTO THE COVER 1. Slide the edges (N) behind the ribs (P) of the cover (L).2. Push the front end of the inser t towards the co...
Page 10 - OPERATION
8 WARNING: After using the tool for an extended period on low speed settings, run it for approximately 3 minutes on maximum no-load speed. Sawing in Wood FIG. 8 1. If necessary, draw a cutting line. 2. Switch the tool on. 3. Hold the tool against the workpiece and follow the line. For sawing paralle...
Page 11 - Lubrication
9 WARNING: Use a cooling lubricant (cutting oil) to prevent overheating of the saw blade or the workpiece. Optional Accessories Consult your dealer for fur ther information on the appropriate accessories.These include: DE3241 Parallel guide DE3242 Trammel bar The following replacement blades are ava...