Page 6 - EC-Declaration of conformity
24 E N G L I S H CORDLESS ROTARY HAMMER DRILLDW004K/DW004K2/DW004K2C/DW004K2H/DW005KH/DW005K2C/DW005K2H Congratulations! You have chosen a D E WALT power tool. Years of experience, thorough product development and innovation make D E WALT one of the most reliable partners for professional power tool...
Page 7 - General
25 E N G L I S H Safety instructions When using Power Tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock andpersonal injury. Read the following safety instructions before attempting to operate this product. Keep these instructions in a ...
Page 8 - E N G L I S H; Additional safety instructions for battery packs; Package contents
26 E N G L I S H Additional safety instructions for battery packs and chargers Fire hazard! Avoid metal short circuitingthe contacts of a detached battery pack. Do not store or carry the battery pack without the battery cap placed over the contacts. • The battery fluid, a 25-30% solution of potassiu...
Page 9 - Charger; Electrical safety
27 Attach the wires to their respective points in the plug (see below). Brown is for Live (L) (2) and Blue is for Neutral (N) (4). • Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correct...
Page 10 - Automatic refresh; AIR COOLED
28 E N G L I S H Do not charge the battery pack at ambient temperatures < 4 °C or > 40 °C. Recommended charging temperature:approx. 24 °C. • To charge the battery pack (9), insert it into the charger (10) as shown and plug in the charger. Be sure that the battery pack is fully seated in the ch...
Page 11 - Inserting and removing SDS-plus accessories
29 Always use the tool with the side handle properly assembled. • Loosen the side handle. • For RH-users, slide the side handle clamp over the collar behind the tool holder, handle at the left. • For LH-users, slide the side handle clamp over the collar behind the tool holder, handle at the right. •...
Page 12 - Lubrication
30 E N G L I S H • Apply only a gentle pressure to the tool. • Do not drill or drive too deep to prevent damage to the dust cover. Switching on and off (fig. A) • To run the tool, press the variable speed switch (1). The pressure exerted on the variable speed switch determines the tool speed. • To s...
Page 13 - Environment; Rechargeable battery pack; G U A R A N T E E; • 30 DAY NO RISK SATISFACTION GUARANTEE •
31 Environment Rechargeable battery pack This long life battery pack must be recharged when it fails to produce sufficient power on jobs which were easily done before. At the end of its technical life, discard it with due care for our environment: • Run the battery pack down completely, then remove ...
Page 14 - EÏÏ¿ ̃; o·Í; T ü r k i y e; M e r k e z M a h a l l e s i , K ö y a l t ı M e v k i i , Ş a h n u r S o k a k
116 Belgique et Luxembourg D E WALT Tel: 02 719 07 11 België en Luxemburg Weihoek 1, Nossegem Fax: 02 721 40 45 1930 Zaventem-Zuid www.dewaltbenelux.com Danmark D E WALT Tlf: 70 20 15 30 Hejrevang 26 B Fax: 48 14 13 99 3450 Allerød www.dewalt-nordic.com Deutschland D E WALT Tel: 06126-21-1 Richard-K...