Dewalt DCS381-XE- Manuals

Page 3 - SAVE THESE INSTRUCTIONS

1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicate...

Page 4 - Electrical Safety

2 c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench...

Page 6 - For best life store battery packs in a cool, dry; Important Safety Instructions for All Battery Packs; READ ALL INSTRUCTIONS

4 • Charge the battery packs only in designated D E WALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 40 ˚ C (105°F) (such as outside sheds or metal buildings in summer). For bes...

Page 7 - Important Safety Instructions for All Battery Chargers; This manual contains important safety and operating; Chargers

5 • Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention. WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame. Important Safety Instructions for All Battery Chargers SAVE THESE INSTRUCTIONS: T...

Page 8 - Indicator Light Operation; Charge Indicators; LEAVING THE BATTERY PACK IN THE CHARGER; Important Charging Notes

6 3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may be used at this time or left in the charger. FIG. 1 F Indicator Light Operation PACK CHARGING PACK CHARGED x HOT/COLD DELAY PROBLEM PACK OR CHARGER PROBLEM POWERLINE Charge I...

Page 9 - Storage Recommendations; SAVE THESE INSTRUCTIONS FOR FUTURE USE

7 c. Move the charger and battery pack to a location where the surrounding air temperature is approximately 18° – 24°C (65°F and 75°F); d. If charging problems persist, take the tool, battery pack and charger to your local service center. 5. The battery pack should be recharged when it fails to prod...

Page 10 - OPERATION

8 OPERATION WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/ installing attachments or accessories. Installing and Removing the Battery Pack (Fig. 4) NOTE: For best results, make sure your battery p...

Page 12 - Cutting with Blade in Horizontal Position; CAUTION

10 Cutting with Blade in Horizontal Position (DCS380-XE only) (Fig. 8) Your DCS380-XE is equipped with a horizontal blade clamp. Installing a blade in the horizontal orientation allows cutting close to floors, walls or ceilings where limited clearance is available. Ensure that the shoe is pressed ag...

Page 13 - costly blade breakage.; MAINTENANCE; Your power tool requires no additional lubrication.

11 POCKET/PLUNGE CUTTING – WOOD ONLY (FIG. 12) The initial step in pocket cutting is to measure the surface area to be cut and mark clearly with a pencil, chalk or scriber. Use the appropriate blade for the application. The blade should be longer than 89 mm (3-1/2") and should extend past the sh...

Page 14 - Cleaning; CHARGER CLEANING INSTRUCTIONS; Repairs

12 Cleaning WARNING: Blow dir t and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear AS/NZS51337 approved eye protection when performing this. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic par ts ...