Dewalt DCS373-XE- Manuals

7 ENGLISH tool that cannot be controlled with the switch is dangerous and must be repaired. c) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the...

8 ENGLISH – When the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator; – If the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of ...

9 ENGLISH • Air vents often cover moving parts and should be avoided. Loose clothes, jewellery or long hair can be caught in moving parts. • Wear ear protectors. Exposure to noise can cause hearing loss. • Wear a dust mask. Exposure to dust particles can cause breathing difficulty and possible injur...

10 ENGLISH • Pull by plug rather than cord when disconnecting charger. This will reduce risk of damage to electric plug and cord. • Make sure that cord is located so that it will not be stepped on, tripped over or otherwise subjected to damage or stress . • Do not use an extension cord unless it is ...

11 ENGLISH If the charger indicates a problem, take the charger and battery pack to be tested at an authorised service centre. HOT/COLD PACK DELAY When the charger detects a battery that is too hot or too cold, it automatically starts a Hot/Cold Pack Delay, suspending charging until the battery has ...

12 ENGLISH Agreement Concerning The International Carriage of Dangerous Goods by Road (ADR). Lithium-ion cells and batteries have been tested to section 38.3 of the UN Recommendations on the Transport of Dangerous Goods Manual of Tests and Criteria. In most instances, shipping a D E WALT battery pac...

13 ENGLISH Package Contents The package contains: 1 Cordless metal-cutting circular saw 1 30 tooth blade 1 Hex key 2 Li-Ion battery packs (M2 models) 1 Kitbox 1 Charger 1 Instruction manual NOTE : Battery packs, chargers and kitboxes are not included with N-models. • Check for damage to the tool, pa...

14 ENGLISH NOTE: The worklight is for lighting the immediate work surface and is not intended to be used as a flashlight. Electrical Safety The electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make ...

15 ENGLISH 2. Retract the lower blade guard (g) and place blade (t) on saw spindle against the inner clamp washer (q), making sure that the blade will rotate in the proper direction (the direction of the rotation arrow on the saw blade and the teeth must point in the same direction as the direction ...

16 ENGLISH Blade Diameter Teeth Application DT1212-QZ 140 mm 30 General purpose (5-1/2") ferrous metal cutting If you need assistance regarding blades, please contact your local D E WALT dealer. KICKBACK Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncont...

18 ENGLISH Proper Hand Position (fi g. 10) WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown. WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden reaction. Proper hand position requires one hand on th...

19 ENGLISH Separate collection of used products and packaging allows materials to be recycled and used again. Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials. Local regulations may provide for separate collection of electrical products from...