Dewalt DCG412-XE- Manuals

6 ENGLISH d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e) Maintain power tools. Check for misalignment or binding of moving pa...

7 ENGLISH capable of stopping small abrasive or workpiece fragments. The eye protection must be capable of stopping flying debris generated by various operations. The dust mask or respirator must be capable of filtrating particles generated by your operation. Prolonged exposure to high intensity noi...

9 ENGLISH Residual Risks In spite of the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be avoided. These are: – Impairment of hearing. – Risk of personal injury due to flying particles. – Risk of burns due to accessories becomi...

10 ENGLISH result in a risk of electric shock, electrocution or fire. • In case of damaged power supply cord the supply cord must be replaced immediately by the manufacturer, its service agent or similar qualified person to prevent any hazard. • Disconnect the charger from the outlet before attempti...

11 ENGLISH • Never force the battery pack into charger. Do not modify the battery pack in any way to fit into a non-compatible charger as battery pack may rupture causing serious personal injury. • Charge the battery packs only in designated D E WALT chargers. • DO NOT splash or immerse in water or ...

12 ENGLISH Storage Recommendations 1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold. For optimum battery performance and life, store battery packs at room temperature when not in use. 2. For long storage, it is recommended to store a fully charg...

13 ENGLISH o. Battery release button p. Fuel gauge button INTENDED USE The DCG412 cordless angle grinder has been designed for professional cutting, light-duty material removal and wire-brush applications. DO NOT use grinding wheels other than centre depressed wheels and flap discs. DO NOT use under...

14 ENGLISH NOTE: The fuel gauge is only an indication of the charge left on the battery pack. It does not indicate tool functionality and is subject to variation based on product components, temperature and end-user application. Attaching Side Handle (fi g. 1) WARNING: Before using the tool, check t...

15 ENGLISH NOTE: Please refer to the Grinding and Cutting Accessory Chart at the end of this section to see other accessories that can be used with these grinders. 1. Place the tool on a table, guard up. 2. Install the unthreaded backing flange (g) on spindle (d) with the raised centre against the w...

16 ENGLISH 4. Close the guard latch to secure the guard on the gear case cover. You should be unable to rotate the guard by hand when the latch is in closed position. Do not operate grinder with a loose guard or clamp lever in open position. 5. To remove the guard, open the guard latch, rotate the g...

17 ENGLISH • Make sure the disc or wheel rotates in the direction of the arrows on the accessory and the tool. • Avoid overloading. Should the tool become hot, let it run a few minutes under no load condition to cool the accessory. Do not touch accessories before they have cooled. The discs become v...

18 ENGLISH kickback if they bend or twist while the tool is being used to do cut-off work or deep grinding. To reduce the risk of serious injury, limit the use of these wheels with a standard Type 27 guard to shallow cutting and notching (less than 13 mm [1/2"] in depth). The open side of the gu...

19 ENGLISH PERSONAL SAFETY 1. No children or pregnant women should enter the work area where the paint removal is being done until all clean up is completed. 2. A dust mask or respirator should be worn by all persons entering the work area. The filter should be replaced daily or whenever the wearer ...

20 ENGLISH MAINTENANCE Your D E WALT power tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. WARNING: To reduce the risk of serious personal injury, turn tool off and disco...

21 ENGLISH D E WALT provides a facility for the collection and recycling of D E WALT products once they have reached the end of their working life. To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. You can check the locat...

22 ENGLISH GRINDING AND CUTTING ACCESSORY CHART Guard Type Accessory Description How to Fit Grinder TYPE 27 GUARD Depressed centre grinding disc Type 27 guard Backing flange Type 27 depressed centre wheel Threaded clamp nut Wire wheels Wire wheels with threaded nut Type 27 guard Wire wheel Wire cup ...