Page 3 - SAFETY INSTRUCTIONS FOR POWER TOOLS
1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicate...
Page 6 - Important Safety Instructions for All Battery Packs; READ ALL INSTRUCTIONS
4 • The label on your tool may include the following symbols. The symbols and their definitions are as follows: V ......................volts A .........................amperes Hz ....................her tz W ........................watts min ..................minutes or AC ............alternating c...
Page 7 - Important Safety Instructions for All Battery Chargers
5 • Charge the battery packs only in designated D E WALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 40 °C (105 °F) (such as outside sheds or metal buildings in summer). For bes...
Page 8 - Charge Indicators
6 • When operating a charger outdoors, always provide a dry location and use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. • Do not place any object on top of the charger or place the charger on a soft surface that might block ...
Page 9 - PROBLEM POWERLINE; Important Charging Notes; SAVE ALL WARNINGS AND INSTRUCTIONS FOR
7 NOTE: This could also mean a problem with a charger. PROBLEM POWERLINE Some chargers have a problem powerline indicator. When the charger is used with some portable power sources such as generators or sources that convert DC to AC, the charger may temporarily suspend operation, flashing the red li...
Page 10 - OPERATION
8 Belt Hook and Bit Clip (Fig. 2) WARNING: To reduce the risk of serious personal injury, turn the tool off and disconnect the battery pack before making any adjustments or removing/installing attachments or accessories. An accidental star t-up can cause injury. WARNING: To reduce the risk of seriou...
Page 12 - Usage; Nm; MAINTENANCE; attachments or accessories.
10 The center position of the control button locks the tool in the OFF position. When changing the position of the control button, be sure the trigger is released. NOTE: The first time the tool is run after changing the direction of rotation, you may hear a click on star t up. This is normal and doe...
Page 13 - Cleaning; CHARGER CLEANING INSTRUCTIONS; Repairs
11 Cleaning WARNING: Blow dir t and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye protection when performing this. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic par ts o...