Dewalt DCD730-XE- Manuals

Page 4 - E N G L I S H; Technical Data

E N G L I S H 33 C O R D L E S S C O M PA C T 1 3 m m ( 1 / 2 " ) D R I L L / D R I V E RD C D 7 3 0 , D C D 7 8 0C O R D L E S S C O M PA C T 1 3 m m ( 1 / 2 " ) D R I L L / D R I V E R /H A M M E R D R I L L D C D 7 3 5 , D C D 7 8 5 Congratulations! You have chosen a D E WALT tool. Years ...

Page 5 - Defi nitions: Safety Guidelines

E N G L I S H 34 Vibration emission value a h Screwdriving a h,ID = m/s² < 2.5 2.5 < 2.5 2.5 Uncertainty K = m/s² 1.5 1.5 1.5 1.5 The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare o...

Page 6 - EC-Declaration of Conformity; MACHINERY DIRECTIVE; General Power Tool Safety Warnings; SAVE ALL WARNINGS AND INSTRUCTIONS

E N G L I S H 35 EC-Declaration of Conformity MACHINERY DIRECTIVE DCD730, DCD735, DCD780, DCD785 D E WALT declares that these products described under Technical Data are in compliance with: 2006/42/EC, EN 60745-1, EN 60745-2-1, EN 60745-2-2. These products also comply with Directive 2004/108/EC and ...

Page 7 - ) BATTERY TOOL USE AND CARE

E N G L I S H 36 d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power too...

Page 8 - Residual Risks; DATE CODE POSITION

E N G L I S H 37 • Wear safety goggles or other eye protection. Hammering and drilling operations cause chips to fly. Flying particles can cause permanent eye damage. • Accessories and tool may get hot during operation. Wear gloves when handling them if performing heat producing applications such as...

Page 9 - SAVE THESE INSTRUCTIONS; Chargers; Charging Process

E N G L I S H 38 • Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire,electric shock or electrocution. • When operating a charger outdoors, always provide a dry location and use an extension cord suitable for outdoor use. Use o...

Page 10 - READ ALL INSTRUCTIONS; Battery Pack; BATTERY TYPE; Storage Recommendations; Labels on Charger and Battery Pack

E N G L I S H 39 Important Safety Instructions for All Battery Packs When ordering replacement battery packs, be sure to include the catalog number and voltage. The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below and ...

Page 11 - Package Contents; NOTE; INTENDED USE

E N G L I S H 40 Read instruction manual before use. Charging. Fully charged. Hot/cold pack delay. x Problem pack or charger. Problem powerline. Do not probe with conductive objects. Do not charge damaged battery packs. Use only with D E WALT battery packs. Others may burst, causing personal injury ...

Page 12 - Electrical Safety; ASSEMBLY AND ADJUSTMENTS; TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE

E N G L I S H 41 Electrical Safety The electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Your D E WALT charger is double ...

Page 14 - OPERATION; RELEASE TRIGGER IMMEDIATELY,

E N G L I S H 43 To move belt hook or bit clip, remove the screw (h) that holds it in place then reassemble on the opposite side. Be sure to securely tighten the screw. OPERATION Instructions for Use WARNING: Always observe the safety instructions and applicable regulations. WARNING: To reduce the r...

Page 15 - MAINTENANCE; CHARGER CLEANING INSTRUCTIONS; Optional Accessories

E N G L I S H 44 NOTE: A smooth, even flow of dust from the hole indicates proper drilling rate. Screwdriver Operation (ﬁ g. 6) 1. Select the desired speed/torque range using the dual range gear selector to match the speed and torque of the planned operation. 2. Turn the torque adjustment collar (c)...

Page 16 - Rechargeable Battery Pack; 0 DAY NO RISK SATISFACTION GUARANTEE

E N G L I S H 45 advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. You can check the location of your nearest authorised repair agent by contacting your local D E WALT office at the address indicated in this manual. Alternatively...