Dewalt DC927-XE- Manuals

Page 3 - SAVE THESE INSTRUCTIONS; Definitions: Safety Guidelines

1 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D E WALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 259 1111 (NZ). SAFETY INSTRUCTIONS FOR POWER TOOLS When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and pe...

Page 4 - Electrical Safety

2 c. Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a...

Page 6 - Important Safety Instructions for All Battery Packs; READ ALL INSTRUCTIONS

4 • Charge the battery packs only in D E WALT chargers. • DO NOT splash or immerse in water or other liquids. • Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 40 ˚ C (105°F) (such as outside sheds or metal buildings in summer). DANGER: Electrocut...

Page 7 - The RBRCTM Seal; Rechargeable Battery Recycling Corporation.; Important Safety Instructions for all Battery Chargers

5 b. and the battery liquid gets into your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical attention. ( Medical note: The liquid is 25-35% solution of potassium hydroxide.) SPECIFIC SAFETY INSTRUCTIONS FOR LITHIUM ION (LI-ION) • Do not incinerate the battery ...

Page 8 - Using Automatic Tune-UpTM Mode

6 • When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. • An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the...

Page 9 - PROBLEM POWER LINE; Important Charging Notes

7 Indicator Light Operation Charge Indicators Some chargers are designed to detect certain problems that can arise with battery packs. Problems are indicated by the red light flashing at a fast rate. If this occurs, re-insert battery pack into the charger. If the problem persists, try a different ba...

Page 10 - Mode Control Collar; Storage Recommendations; SAVE THESE INSTRUCTIONS FOR FUTURE USE; KEY FEATURES AND FUNCTIONS

8 The center position of the control button locks the tool in the OFF position. When changing the position of the control button, be sure the trigger is released. NOTE: The first time the tool is run after changing the direction of rotation, you may hear a click on star t up. This is normal and does...

Page 11 - TO INSERT A DRILL BIT OR OTHER ACCESSORY; front) far enough to accept the desired accessory.; OPERATION; installing attachments or accessories.

9 2. Rotate the mode control collar (C) so the screw symbol is aligned with the arrow. 3. Set the torque adjustment collar (D) to the appropriate number setting for the torque desired. NOTE: The torque adjustment collar may be set on any number and change between screwdriving and drilling modes usin...

Page 14 - WALT Reserves the right to; 0 DAY NO SATISFACTION GUARANTEE; If you are dissatisfied with any D; FREE WARNING LABEL REPLACEMENT:; If your warning labels become illegible or

12 NOTE: Three Year Warranty is not applicable to items deemed as consumables. Radial arm saws are covered by a one (1) year warranty only. D E WALT Reserves the right to review its warranty policy prior to launch of any new business development products. 30 DAY NO SATISFACTION GUARANTEE If you are ...