Page 3 - SAVE THESE INSTRUCTIONS; Definitions: Safety Guidelines
1 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D E WALT TOOL, CALL US AT: 1800 654 155 (Aust) or 0800 339258 (NZ). SAFETY INSTRUCTIONS FOR POWER TOOLS When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and pe...
Page 4 - Electrical Safety
2 e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. 3) PERSONAL SAFETY a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool w...
Page 5 - Extension Cords; MINIMUM GAUGE FOR CORD SETS; Safety Warnings for Heat Guns
3 Extension Cords CAUTION: Use only extension cords that are approved by the country’s Electrical Authority. Before using extension cords, inspect them for loose or exposed wires, damaged insulation and defective fittings. Replace the cord if necessary. MINIMUM GAUGE FOR CORD SETS For Cable length (...
Page 7 - exposed areas with soap and water.; Specifications; INTENDED USE
5 • arsenic and chromium from chemically-treated lumber (CCA). Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that ar...
Page 8 - ASSEMBLY AND ADJUSTMENTS; installing attachments or accessories.
6 FIG.1 A C B D E F G D26414-XE H ASSEMBLY AND ADJUSTMENTS WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/ installing attachments or accessories. Setting the Air Temperature (Fig. 1) The air temper...
Page 9 - OPERATION; Stripping Paint
7 Icon Description Purpose 20 φ Cone nozzle Welding, shrink sleeving (heat concentrated over small area) 50 mm Fish tail Drying, thawing surface nozzle (heat spread over wide area) 1. Make sure the on/off switch (A) is in position "O" and the tool is disconnected from the power source. Ensur...
Page 10 - MAINTENANCE; attachments or accessories.; Lubrication
8 NOTE: To reduce the cooling time, switch the tool on at the lowest air temperature setting and let it run for a few minutes before turning the heat gun off. MAINTENANCE WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect battery pack before making any adjustments o...
Page 11 - FREE ONE YEAR SERVICE CONTRACT
9 Guarantee Applicable to hand held Power Tools, Lasers and Nailers. Three Year Limited Warranty D E WALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the date of purchase. Please return the complete unit, transpor tation prepaid, to any D E WA...