Page 2 - SAFETY INFORMATION; a qualified installer.; TABLE OF CONTENTS
www.desatech.com 119668-01A SAFETY INFORMATION WARNING: Improper installa- tion, adjustment, alteration, ser- vice or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer. WARNING: Risk of fire. Keep combustibl...
Page 3 - Continued; Frequency
www.desatech.com 119668-01A 3 SAFETY INFORMATION Continued 13. When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage the unit. LISTING APPROVALS This heater has been tested in accordance with the CSA Standards for fix...
Page 4 - Figure 2 - Grounding Methods; OPERATING; Note; CONTROl PANel OPeRATION; ember Control Dial:; OPeRATING by ReMOTe CONTROl; electric fireplace by remote, the; Main Power Switch
www.desatech.com 119668-01A 4 GROUNDING INSTRUCTIONS This stove is for use on 120 volts. The cord has a plug as shown in Figure 2. An adapter is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding plug extending from the adapter must be connected to...
Page 5 - To increase the flame intensity,
www.desatech.com 119668-01A 5 FLAME TEMP. CONTROL POWER ON/OFF ON/OFF ON/OFF HIGH HIGHER MED LOW LOWER Dimmer Brighter EMBERS/ LOGSET HEATER DISPLAY OPERATING INSTRUCTIONS Continued 5. Heater Button: To activate the heater, press the heater button, then press HI, MED or LO. The heater is pre-set to ...
Page 6 - bUlb RePlACeMeNT; specified maximum watts.; Replacing log Set ember bed bulb; Figure 5 - Ember Bed Bulb Location
www.desatech.com 119668-01A 6 CLEANING AND MAINTENANCE WARNING: Always discon- nect power and allow the heater to cool before performing any cleaning, maintenance or reloca- tion of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater. Turn off heater a...
Page 7 - CLEANING AND; Figure 7 - Flame Cylinder Drum Location; Replacing Glass; Figure 9 - Removing Top of Stove
www.desatech.com 119668-01A Flame Cylinder Drum Figure 8 - Flame Generation Cylinder Drum CLEANING AND MAINTENANCE Continued Flame Cylinder Drum Figure 7 - Flame Cylinder Drum Location 2. Locate flame generation cylindrical drum (see Figure 7). It is constructed of two removable halves; either of wh...
Page 8 - STORAGe; TECHNICAL SERVICE; PARTS UNDeR WARRANTy; Replacing log; Replacing; CleANING FRONT PANel GlASS
www.desatech.com 119668-01A 8 STORAGe When not in use, unplug the unit from the power supply and store in dry, dust free location. TECHNICAL SERVICE You may have further questions about your elec- tric stove. If so, contact DESA Heating Products’ Technical Service Department at 1-866-672-6040. When ...
Page 9 - TROUBLESHOOTING; WARNING: Turn off appliance and let cool before servicing. Only; POSSIble CAUSe
www.desatech.com 119668-01A 9 TROUBLESHOOTING WARNING: Turn off appliance and let cool before servicing. Only a qualified service person should service and repair heater. POSSIble CAUSe ReMeDy ObSeRVeD PRObleM 1. Stove has overheated and safe- ty devise has cause thermal switch to disconnect, home c...
Page 10 - ILLUSTRATED PARTS BREAkDOWN; MODelS CGeSbMRA AND VeSbMRA
www.desatech.com 119668-01A 10 ILLUSTRATED PARTS BREAkDOWN MODelS CGeSbMRA AND VeSbMRA 1 2 13 14 15 6 16 9 8 5 10 11 12 7 4 3
Page 11 - PARTS LIST; listed under
www.desatech.com 119668-01A 11 PARTS LIST MODelS CGeSbMRA AND VeSbMRA This list contains replaceable parts used in your fireplace. When ordering parts, follow the instructions listed under Replacement Parts on page 8 of this manual. KEY NO. PART NO. DeSCRIPTION QTy. 1 1108-01 Blower and Heater Assem...
Page 12 - WARRANTY INFORMATION; kEEP THIS WARRANTY; Model; LIMITED WARRANTY; NOT A UPC
WARRANTY INFORMATION kEEP THIS WARRANTY Model Serial No. Date Purchased 119668-01Rev. A06/06 01 Industrial DriveP.O. Box 90004Bowling Green, KY 410-9004www.desatech.com LIMITED WARRANTY ELECTRIC STOVE DESA Heating Products warrants this product to be free from defects in materials and components for...