Desa BV125EDI - Manuals - manualsarea.com

Page 2 - CONTENTS; SECTION

2 Flame-out Information ................................................................... 3 Introduction ................................................................................... 4 Product Identiﬁcation .................................................................... 4 Unpacking .......

Page 3 - WARNINGS; Carbon Monoxide Poisoning:; DANGER; Carbon monoxide poisoning may lead to death!

3 SAFETY INFORMATION WARNINGS ! IMPORTANT: Read this Owner’s Manual carefully and completelybefore trying to assemble, operate, or service this heater. Improper useof this heater can cause serious injury or death from burns, fire,explosion, electrical shock, and carbon monoxide poisoning. Carbon Mon...

Page 4 - INTRODUCTION; PRODUCT

4 INTRODUCTION Fuel Cap LowerShell Power Cord Figure 1 - BV125EDI Hot AirOutlet Flame-OutControl ResetButton FuelTank Fan Guard Air FilterEnd Cover PRODUCT IDENTIFICATION UNPACKING Upper Shell Interrupter This heater is designed to provide heated air. The heated air is free of harmfulexhaust gases. ...

Page 5 - ASSEMBLY; Tools Needed

5 ASSEMBLY This heater is furnished with wheels, handles, and an interrupter. These items andthe mounting hardware are found in the shipping carton. Tools Needed • Medium Phillips Screwdriver• 3/8" Open or Adjustable Wrench• Hammer 1. Slide axle through wheel support frame. Install wheels on axl...

Page 6 - THEORY OF; WARNING; FUELS; The Ignition System:

6 THEORY CUTAWAY 125 EURO THEORY OF OPERATION WARNING ! FUELS Use only kerosene or No. 1 fuel oil to avoid risk of fire orexplosion. Never use gasoline, naphtha, paint thinners,alcohol, or other highly flammable fuels. CleanHeatedAir Out CoolAirIn OutputAirFilter Figure 3 - Cross Section Operational...

Page 7 - VENTILATION; OPERATION; To Start Heater

7 VENTILATION WARNING ! A standard 4 inch (10.16 cm) draft regulator is required only if total vertical andhorizontal length of the vent pipe exceeds 20 feet (6.1 meters). Regulator, ventpipe, and ﬁttings are not supplied with the heater. Purchase these items at a localhardware store. OPERATION Figu...

Page 8 - PREVENTATIVE; Item

8 OPERATION Continued To Stop Heater 1. Unplug power cord from outlet. To Restart Heater 1. Wait 2 minutes after stopping heater.2. Repeat steps under To Start Heater, page 7. WARNING ! PREVENTATIVE MAINTENANCE SCHEDULE STORAGE 1. Drain fuel tank. Locate drain plug on underside of fuel tank. Remove ...

Page 9 - SHOOTING; OBSERVED FAULT

9 WARNING ! TROUBLE- SHOOTING OBSERVED FAULT POSSIBLE CAUSE REMEDY Wrong pump pressure Dirty air output, air intake and lint ﬁlters Dirty fuel ﬁlter Dirt in nozzle Dirty photocell lens Bad flame-out control See Pump Pressure Adjustment, page 11. See Air Output, Air Intake and Lint Filters, page 11. ...

Page 10 - Upper Shell Removal; Fan

10 SERVICE PROCEDURES WARNING ! Upper Shell Removal 1. Remove screws along each side of heater using 5/16"nut-driver. These screwsattach upper and lowershells together. 2. Lift upper shell off.3. Remove fan guard. 125 SHELL REMOVAL PFA/P 050 UpperShell Fan Guard Figure 6 - Upper Shell Removal Ne...

Page 12 - Spark Plug

12 Fuel Filter 1. Remove upper shell (see page 10). 2. Remove fan (see page 10).3. Loosen ﬂare nut using 3/4" open-end wrench. Push fueltube down, away fromburner head. Fuel ﬁlter islocated inside of fuel tube. 4. Lift out fuel ﬁlter.5. Wash fuel ﬁlter with clean fuel and replace in fueltube. 6....

Page 13 - Nozzle

13 Nozzle 1. Remove upper shell (see page 10). 2. Remove fan (see page 10).3. Remove spark plug wire from spark plug. 4. Remove spark plug from burner head using 13/16"open-end wrench. 5. Loosen ﬂare nut using 3/4" open-end wrench.Push fuel tube down. 6. Remove air line hose from burner head...

Page 14 - Pump Rotor

14 125 ROTOR PFA/P 058 Pump Rotor (Procedure if rotor is binding) 1. Remove upper shell (see page 10). 2. Remove ﬁlter end cover screws using 5/16" nut-driver. 3. Remove ﬁlter end cover and air ﬁlters. 4. Remove pump plate screws using 5/16" nut-driver. 5. Remove pump plate.6. Remove rotor, ...

Page 17 - PARTS LIST; WHEELS AND HANDLES

17 PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, be sureto provide the correct model and serial numbers (from the model plate), then the partnumber and description of the desired part. 7 KEY PART PART NO. NUMBER DESCRIPTION QTY. 1 HA2205 Handles 2 2 M12345...

Page 19 - NOTES

Page 20 - WARRANTY AND REPAIR SERVICE; CERTIFICATE OF GENERAL; DESA; INTERNATIONAL

WARRANTY AND REPAIR SERVICE POSE. IN ANY EVENT IMPLIED WARRANTIES INCLUDINGTHOSE OF MERCHANTABILITY AND FITNESS FOR A PAR-TICULAR PURPOSE ARE LIMITED TO THE DURATION OFTHIS EXPRESS WARRANTY. Any transportation charges, costs of installation, duty, taxes or any other charges whatsoever must be borne ...