Denon DN-C680 - Manuals

• 19 inch Rack Mountable (Height 3U) • Large FL Display, Illuminated Rubber Button • Track Search Select knob (Easy track selection) • Jog/ Shuttle Wheel Perform searches to 1 frame precision using the jog dial and easy scans using the shuttle ring. • Program Play (Max. 25 tracks) (1) When the PLAY ...

CONTENTS Checking the Contents Check that the carton contains the following items: 3P power supply cord 1 PC. Operating instructions (this booklet) 1 PC. Installing the Units Mount the units onto your console or rack with 19" EIA rack rails. CAUTION: • The DN-C680 will work normally when the pla...

PART NAMES AND FUNCTIONS (1) Front Panel POWER button • This turns the set on and off. Disc holder • Place discs in this holder. Press the OPEN/CLOSE button to open and close the disc holder. Load discs firmly inside the slot. OPEN/ CLOSE button • Press this button to open and close the disc holder....

RS232C/RS422A connector • This is a serial remote connector. A personal computer or other external controller can be connected to control the DN-C680 externally. • Applicable connector: 9-pin D-sub (female) • Baud rate: 9600 bps or 19200 bps • Pin layout: RS232C RS422A Pin no. Signal name I/0 Signal...

(2) Starting Playback (3) Stopping Playback Sleep mode The sleep mode is set if no operation is performed for 30 min-utes in the standby, pause or manual search mode. When in the sleep mode, press the PLAY/PAUSE button to search for the position before the sleep mode was set and start playback. Pres...

HANDY OPERATIONS (1) Starting Playback from the Middle of a Track (Manual Search) • When a track is selected and the PLAY/PAUSE button is pressed, playback starts from the beginning of that track. To start from a different position in the track, use the procedure described below to find the desired ...

19 PROGRAMMED PLAYBACK • The tracks can be programmed to play in a certain order. • Up to 25 tracks can be programmed. • Programmed playback is performed according to the play mode (single or continuous) and finish mode (stop, next or recue) settings. (2) Changing the Program To exit the program edi...

21 (4) Presetting Programs • Programs can be stored in the preset memory. When a disc for which a program is preset is loaded, the programmed playback mode is set automatically. • Programs can be stored for up to three discs.

• Functions can be preset using the buttons on the front panel. These presettings are stored in a permanent memory, so they are not cleared even when the power is turned off. • The functions shown on the table below can be preset. Set the functions according to the usage purpose to efficiently achie...

24 (3) Detailed Description of Preset Functions (* = initial setting) 1) "Preset Type (*1" (Three different sets (types) of presettings can be made and used for different purposes.) * Preset Type1 : Set to preset type 1. Preset Type2 : Set to preset type 2. Preset Type3 : Set to preset type ...

26 BEFORE SWITCHING OFF THE POWER When you have finished using the CD player, before switching off the power be sure that the disc holder has been closed with the OPEN/CLOSE button. CAUTION: Do not forcibly close the disc holder when the power is off. It may damage the unit when it is transported. C...