Defy DHG 122 - Manuals - manualsarea.com

Page 2 - Important: Read these; This book; Know your product; CONTROL KNOBS FOR RELEVANT BURNERS; Introduction

PAGE 2 OF 16 Congratulations on the purchase of this quality appliance. We trust that you will enjoy many years of trouble free use. Important: Read these instructions for use carefully so as to familiarize yourself with the appliance before connecting it to its gas container. Keep these instruction...

Page 3 - Permanent installation. Important information for the user.; Failure to comply with the above will render the warranty invalid.; Important information for the installer.; The requirements for safe operation of the appliance.; Safety compliance with local requirements.

PAGE 3 OF 16 Permanent installation. Important information for the user. The appliance may only be installed by a registered LP Gas installer. All registered installers are issued with a card carrying their registration number. Ask to be shown this card before allowing the installation to commence a...

Page 4 - Carefully tighten the fixing hooks.; Installation

PAGE 4 OF 16 The necessary installation instructions, including gas and electrical connections are described below. They must be carried out by qualified personnel in accordance with current and local regulations, since an installation by an unqualified person may constitute a hazard. The manufactur...

Page 5 - Gas cylinder; minimum capacity of 19kg be used.; Regulator; The connecting hose should not exceed 125 cm in length.; See sketch on next page.

PAGE 5 OF 16 Electrical connection This appliance must be earthed and the manufacturer and the seller do not accept responsibility for any damage due to incorrect installation or electrical connection. The mains supply must correspond with the data specified on the rating plate located on the base o...

Page 6 - Check for gas leaks

PAGE 6 OF 16 H o b ga s p ip e G a ske t G a ske t C o p pe r pipe Al te rn at ive s F le xible h os e an d ho s e cla m p Check for gas leaks • Check for gas leaks after installation and whenever a new or re-filled gas cylinder is used for the first time. • Never use a naked flame to check for gas ...

Page 7 - Using the hob; Operating the gas burners; A spark is created and the gas ignites.; Burner use

PAGE 7 OF 16 Using the hob Operating the gas burners • To switch the burner on, push down on the relevant control knob and then turn it to the left. (counter clockwise) to the large flame symbol • A spark is created and the gas ignites. • Keep the knob depressed for an additional 3 to 5 seconds to e...

Page 8 - Cleaning; Do Not Use

PAGE 8 OF 16 Flame adjustment Should you find it necessary, the flame may be ad-justed as follows: • Remove the burner knobs (push on type) • Light the burners and adjust the minimum flame by turning the adjustment screw clockwise to decrease and anti-clockwise to increase it. • The adjustment screw...

Page 9 - Cleaning continued; Fitting the burner caps.

PAGE 9 OF 16 Cleaning continued BURNER BODY BURNER CAP FLAME FAILURE SENSOR IGNITION ELECTRODE • Carefully align the hole in the burner body with the flame failure sensor. • Gently lower the burner body into position. • Centralise and level the burner cap onto the burner body. (The burner cap must b...

Page 10 - Requires routine cleaning; Care guide for stainless steel

PAGE 10 OF 16 Condition Action Notes and comments Requires routine cleaning Mild detergent solution ap-plied with soft sponge or cloth. Rinse and wipe dry. If possible use warm to hand-hot water. A 5% addition of ammonia is beneficial. Finger prints Pre-treat finger marks with alcohol or an organic ...

Page 11 - Safety notes

PAGE 11 OF 16 This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their sa...

Page 12 - Technical specifications

PAGE 12 OF 16 Technical specifications II 2H3 + (G20= 2.0 kPa ..G30=2.8—3.0/3.7 kPa) 2.0 kPa 2.8-3.0/3.7 kPa The Manufacturer strives for continuous improvements. For this reason, the text and illustrations in this book are subject to change without notice. 1. AUXILIARY BURNER 2. SEMI-RAPID BURNERS ...

Page 13 - warranty period, if the fault is due to or caused by any of the above.; Do not attempt to repair the appliance yourself.; Problem; Owner’s responsibility

PAGE 13 OF 16 • Check house fuses or trip switches. • Check the wall plug by plugging another small appliance into the wall socket. • Check that there is gas in the cylinder and that the valve is open. • Smoke and smell may be emitted for the first few hours of use. This is normal and is no cause fo...

Page 14 - Defy Service Centres

PAGE 14 OF 16 Other areas are serviced by over 200 authorised agents. Consult the nearest regional Service Centre for details. Defy Service Centres If you have followed the instructions and still have a problem, contact the near-est Defy Service Centre. They will be able to advise you on any aspect ...

Page 15 - KEEP THIS CERTIFICATE AND SALES INVOICE AS PROOF OF PURCHASE FOR; Warranty

PAGE 15 OF 16 This certificate is issued by DEFY APPLIANCES (PTY) LTD manufacturers of Defy and Ocean products, hereinafter the Company, to the original purchaser only, of the appliance described on the certificate and shall constitute the only warranty given in respect of this appliance. The Compan...

Page 16 - Please register your product at; Installer’s details to be recorded below

PAGE 16 OF 16 Please register your product at www.defy.co.za For future reference, record the listed information in the space below. The Serial number may be found at the base of the hob SERIAL NUMBER:HHHHHHHHHHHHHHHHHHHHHHHHHHHH.. DATE OF PURCHASE:HHHHHHHHHHHHHHHHHHHHHHHHHH... PURCHASED FROM:HHHHHH...