Dacor PD - Manuals

4 Preparing for Installation WARNING Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Preparing the Location Carefully check the location where the dishwasher is to be installed. Put it in a location with con...

5 Preparing for Installation WARNING The electrical power supply for the dishwasher must be installed only by a licensed electrician as specified below. It is the owner’s responsibility to ensure that the electrical connection of this appliance is performed by a licensed electrician. Electrical Spec...

6 Installation Specifications Verify the Package Contents NOtE : Model ID24 ships without a front panel. It is designed for the installation of an integrated front panel that matches the surrounding cabinets. With the assistance of at least one person, remove the • dishwasher from the shipping carto...

7 Installation Specifications WARNING Do not install the dishwasher unless the electrical • service provided meets the dishwasher specifications (see page 5).A qualified technician must complete the installation • of this built-in appliance. The owner is responsible to make sure the dishwasher is pr...

8 Installation Instructions Feed the electric cord (or wire) and both hoses into the utility cut-out(s); direction varies with installation. Utility Cut-outs Hoses Wire or cord * Does not apply when using a 3-Prong power cord. Standard 3-Wire Connection to House Junction Box* To house circuit breake...

9 Measure the height of the front and back of the cut-out 1. with a tape measure.Measure the height of of the front and back of the 2. dishwasher.Using a crescent wrench, loosen the leg nut on all four 3. legs and turn the legs to adjust them. The maximum height of the dishwasher must be 1/8” lower ...

10 Installation Instructions Side anti-tip bracket Top anti-tip bracket     NOtE : The leg nuts can be removed to make the dishwasher lower. To do so: Turn the leg until it comes out of the chassis. • Remove the nut from the leg. • Re-thread the leg into the chassis. • Reach inside the chassis a...

11 Installation Instructions Create loop and fasten to under side of cabinet Floor DISPOSAL INStALLAtION WItHOUt AIR GAP 20" Min. Create loop and fasten to under side of cabinet Floor WAStE tEE INStALLAtION WItHOUt AIR GAP INStALLAtION WItH AIR GAP AND DISPOSAL INStALLAtION WItH AIR GAP AND WASt...

12 Installation Instructions WARNING To ensure a safe and proper installation, the following • checklist should be completed by the installer to ensure that no part of the installation has been overlooked and the unit is working properly.Proper installation is the responsibility of the • homeowner. ...