Dacor 100500 - Manuals

Overlay Panel Specifications (See Illustrations on page 3.) 42-Inch Model 48-Inch Model BACKER PANEL (A) Grille Panel W Width 40 1/4” (1022mm) 46 1/4” (1175mm) H Height 8 3/4” (222mm) 8 3/4” (222mm) (B) Freezer Dispenser Panel W Width 16 1/4” (413mm) 18 1/2” (470mm) W1 Width 2” (51mm) 2” (51mm) W2 W...

d esign s PeCifiCaTions Custom Toe Kickplate Specifications If using custom toe kickplate with your Dacor ® Built-In Refrigerator, refer to the following specifications. “C” 3" 3 3/4" R. 1/2" Non-Dispenser 2 3/16" Typ 7/8" 5/16" 4 13/16" 5 5/8" 1 1/8" Typ 6 1/4...

i nsTallaTion s PeCifiCaTions T ools and P aRTs IMPORTANT: ◊ Installer: Leave these Installation Instructions with the homeowner. ◊ Homeowner: Keep these Installation Instructions for future reference. Save these Installation Instructions for the local electrical inspector’s use. Tools needed: Make ...

Rough-In Dimensions ◊ The solid sofit or ceiling should be within 1” (25mm) above the refrigerator. If the solid sofit is higher than 1” (25mm) or one is not available, then the refrigerator must be braced to prevent tipping during use. If the anti-tip blocking is need. (see “Anti-Tip Blocking” on p...

i nsTallaTion i nsTRuCTions u nPaCk R efRigeRaToR WARNING TIP OvER HAzARD – Refrigerator is top heavy and tips easily when not completely installed, Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can resul...

i nsTallaTion i nsTRuCTions i nsTall C usTom P anels Panel Installation Before you begin installing panels, refer to the “Custom Panel Specifications” for overlay models and verify that you are working with the panel design called for in your installation. If you have chosen the stainless steel desi...

7. Remove the four #15 Torx plastic collar screws from the fountain/escutcheon collar. 8. Place the fountain/ escutcheon collar onto the backer panel. Use tape to hold in place. 9. Open the freezer door and slide panel onto the door. 10. The holes in the fountain/escutcheon collar should line up wit...

i nsTallaTion i nsTRuCTions Side Panel Installation If using side panels with the Dacor ® Built-In Refrigerator, they will need to be 1/4-inch thick. Slide the panel into position and secure with screws indicated by the shaded area. A 3/16-inch spacer is required between the cabinet and side panel. ...

The importance of the proper installation of your Dacor Built-In Refrigerator cannot be overemphasized. Proper installation is the responsibility of the homeowner. IMPORTANT: To ensure a safe and proper installation, the following checklist should be competed by the installer to ensure that no part ...