D-Link BEFCMU10 - Manuals - manualsarea.com

Page 3 - Introduction; Table of Contents

EtherFast ® Cable Modem with USB and Ethernet Connection Introduction The Instant Broadband TM Cable Modem with USB and Ethernet Connection Congratulations on the purchase of your new Instant Broadband TM Cable Modem with USB and Ethernet Connection. With cable’s high-speed Internetaccess, now you c...

Page 4 - Getting to Know the Cable

Instant Broadband TM Series Package Contents • One EtherFast ® Cable Modem with USB and Ethernet Connection • One AC Adapter • One Power Cord • One USB Cable • One Setup Utility CD• Electronic User Guide (on Setup Utility CD)• One Registration Card System Requirements • CD-ROM drive• PC running Wind...

Page 5 - USB Type A; There is no USB Support on PCs run-

EtherFast ® Cable Modem with USB and Ethernet Connection 5 4 The Cable Modem with USB and Ethernet Connection’s Rear Panel Cable Port The cable from your Internet Service Provider connects here. It is a roundcoaxial cable, exactly like the one thatconnects to the back of your cable box(if you have o...

Page 6 - Connecting the Cable Modem

7 EtherFast ® Cable Modem with USB and Ethernet Connection Connecting the Cable Modem with USB to Your PC Connecting Using the Ethernet Port 1. Make sure that you have TCP/IP installed on your computer. If you don’t know what TCP/IP is or you don’t have it installed, refer to the section in theAppen...

Page 7 - If you are installing drivers for

9 8 EtherFast ® Cable Modem with USB and Ethernet Connection Instant Broadband TM Series 1. When the Add New Hardware Wizard window appears, insert the Setup Utility CD into your CD-ROM drive and click Next. 2. Select Search for the best driver for your device and click the Next but- ton. Installing...

Page 12 - Troubleshooting

The Cable Status LED never stops blinking. The signal from your cable company's equipment may be too weak or thecable line may not be properly attached to the modem. If the cable line isproperly connected to the modem, call your cable company to verifywhether or not a weak signal may be the problem....

Page 13 - Appendix

Appendix Follow these instructions to install the TCP/IP Protocol on one of your PCsonly after a network card has been successfully installed inside the PC. Theseinstructions are for Windows 95, 98 or Milliennium. For TCP/IP setup underMicrosoft Windows NT or 2000, please refer to your Microsoft Win...

Page 15 - Specifications; For Windows NT and 2000 users:

25 Specifications pecifications Model No: BEFCMU10 Standards: IEEE 802.3 (10BaseT), IEEE 802.3u(100BaseTX), DOCSIS 1.0 USB Specifications 1.1 Downstream: Modulation 64QAM, 256QAMData Rate 30Mbps (64QAM), 43Mbps (256QAM) Frequency Range 88MHz to 860MHz Bandwidth 6MHz Input Signal Level -15dBmV to +15...

Page 16 - Contact Information; Warranty Information

Instant Broadband TM Series 26 Contact Information For help with the installation or operation of this product, contact LinksysCustomer Support at one of the phone numbers or Internet addresses below. Information 800-546-5797 (LINKSYS) Tech Support and RMA Issues 800-326-7114 Fax 949-261-8868 Email ...